Cisco인증 200-125기출문제을 패스하는 지름길은Pass4Test에서 연구제작한 Cisco 인증200-125기출문제대비 덤프를 마련하여 충분한 시험준비를 하는것입니다. 덤프는 Cisco 인증200-125기출문제의 모든 범위가 포함되어 있어 시험적중율이 높습니다. Cisco 인증200-125기출문제패는 바로 눈앞에 있습니다. 링크를 클릭하시고Pass4Test의Cisco 인증200-125기출문제대비 덤프를 장바구니에 담고 결제마친후 덤프를 받아 공부하는것입니다.
Cisco 200-105인증덤프패스는 어려운 일이 아닙니다. Pass4Test의 Cisco 200-105인증덤프 덤프로 시험을 쉽게 패스한 분이 헤아릴수 없을 만큼 많습니다. Cisco 200-105인증덤프의 데모를 다운받아 보시면 구매결정이 훨씬 쉬워질것입니다. 하루 빨리 덤프를 받아서 시험패스하고 자격증 따보세요.
시험 번호/코드: 200-125시험 이름: CCNA Cisco Certified Network Associate CCNA (v3.0)
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 200-125기출문제
PDF 및 소프트웨어, 연구와 실천
시험 번호/코드: 200-105시험 이름: Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0)
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 200-105인증덤프
PDF 및 소프트웨어, 연구와 실천
IT업계의 치열한 경쟁속에 살아 남으려면 자신의 능력을 증명하여야 합니다. 국제승인을 받는 IT인증자격증을 많이 취득하시면 취직이든 승진이든 이직이든 모든 면에서 이득을 볼수 있습니다. 최근 Cisco인증 200-125기출문제에 도전하는 분이 많은데 Pass4Test에서 Cisco인증 200-125기출문제에 대비한 가장 최신버전 덤프공부가이드를 제공해드립니다.
200-125 덤프무료샘플다운로드하기: http://www.pass4test.net/200-125.html
NO.1 Which three statements about link-state routing are true? (Choose
three.)
A. RIP is a link-state protocol.
B. Routes are updated when a
change in topology occurs.
C. Updates are sent to a broadcast address.
D.
It uses split horizon.
E. OSPF is a link-state protocol.
F. Updates are
sent to a multicast address by default.
Answer: B,E,F
200-125자료
NO.2 An
administrator is trying to ping and telnet from SwitchC to RouterC with the
results shown
below.
Click the console connected to RouterC and issue the
appropriate commands to answer the
questions.
What would be the effect of
issuing the command ip access-group 115 in on the s0/0/1 interface?
A. No
host could connect to RouterC through s0/0/1.
B. Telnet and ping would work
but routing updates would fail.
C. Only traffic from the 10.4.4.0 network
would pass through the interface.
D. FTP, FTP-DATA, echo, and www would work
but telnet would fail.
Answer: A
200-125자격증시험
Explanation:
First
let's see what was configured on interface S0/0/1:
NO.3 Refer to the
exhibit.
At the end of an RSTP election process, which access layer switch
port will assume the discarding
role?
A. Switch3, port fa0/12
B.
Switch3, port Gi0/1
C. Switch3, port fa0/1
D. Switch4, port fa0/11
E.
Switch4, port fa0/2
F. Switch3, port Gi0/2
Answer: D
200-125
IT자격증
Explanation:
In this question, we only care about the Access
Layer switches (Switch3 & 4). Switch 3 has a lower
bridge ID than Switch
4 (because the MAC of Switch3 is smaller than that of Switch4) so both ports
of
Switch3 will be in forwarding state. The alternative port will
surely
belong to Switch4.
Switch4 will need to block one of its ports to
avoid a bridging loop between the two
switches. But how does Switch4 select
its blocked port? Well, the answer is based on the
BPDUs it receives from
Switch3. A BPDU is superior to another if it has:
1.A lower Root Bridge
ID
2.A lower path cost to the Root
3.A lower Sending Bridge ID
NO.4
Which three elements must be used when you configure a router interface for VLAN
trunking?
(Choose three.)
A. subinterface encapsulation identifiers that
match VLAN tags
B. subinterface numbering that matches VLAN tags
C. one IP
network or subnetwork for each subinterface
D. one subinterface per
VLAN
E. a management domain for each subinterface
F. one physical
interface for each subinterface
Answer: A,C,D
200-125국제공인자격증
Explanation:
This
scenario is commonly called a router on a stick. A short, well written article
on this operation can
be found
here:
http://www.thebryantadvantage.com/RouterOnAStickCCNACertificationExamTutorial.htm