많은 사이트에서  Cisco 648-247 (Implementing Cisco Connected Physical Security 2 Exam) 시험대비덤프를 제공해드리는데 Pass4Test를 최강 추천합니다. Pass4Test의 Cisco 648-247 (Implementi ng Cisco Connected Physical Security 2 Exam) 덤프에는 실제시험문제의 기출문제와 예상문제가 수록되어있어 그 품질 하나 끝내줍니다.적중율 좋고 가격저렴한 고품질 덤프는 Pass4Test에 있습니다.

 

 

NO.1 What are the three common methods that are used for authentication with an access control system.?
A. badge card, key fob, and keypad PIN
B. badge card, keypad PIN, and password
C. something you know, something you have, and something you are
D. something you know, something you have, and something you did
Answer: C

NO.2 Cisco Physical Access Manager (Cisco PAM) is an appliance-based solution. The Cisco PAM 1.3.2
appliance is available on which of the following server platforms?
A. CIVS-MSP-1RU-K9
B. CPS-MSP-1RU-K9
C. CPS-MSP-2RU-K9
D. CIAC-PAME-1125-K9
Answer: B

NO.3 When a 24 VDC fail safe lock is being used to secure a door, how should power be supplied to the lock
from the control source?
A. connected +24 VDC directly to the lock
B. connected +24 VDC through common and normally close
C. connected +24 VDC through common and normally open
D. connected +5 VDC binary control signaling
Answer: B

NO.4 What are the four main components of a typical logical door?
A. door, door knob, door jam, and hinges
B. lock, reader, tailgate sensor, and motion detector
C. lock, request to exit, door position switch, and swing arm
D. lock, reader, request to exit, and door position switch
Answer: D

NO.5 Refer to the exhibit.
One or more expansion modules is connected to the Cisco Access Gateway via a CAN bus. How should
the CAN bus wires be connected after the last module in the chain?
A. The CAN bus wires should be looped back to the Cisco Access Gateway.
B. The CAN bus wires should be twisted together and tucked away.
C. The CAN bus wires should be plugged into a Layer 2 Ethernet switch.
D. The CAN bus wires should be terminated with a high-impedance resistor.
Answer: D