많은 사이트에서 Cisco 300-101 (Implementing Cisco IP Routing (ROUTE v2.0))인증시험대비자료를 제공하고 있습니다. 그중에서 Pass4Test를 선택한 분들은 Cisco 300-101 (Implementing Cisco IP Routing (ROUTE v2.0))시험통과의 지름길에 오른것과 같습니다. Pass4Test는 시험에서 불합격성적표를 받으시면 덤프비용을 환불하는 서
비스를 제공해드려 아무런 걱정없이 시험에 도전하도록 힘이 되어드립니다. Pass4Test덤프를 사용하여 시험에서 통과하신 분이 전해주신 희소식이 Pass4Test 덤프품질을 증명해드립니다.
NO.1 A network engineer has been asked to ensure that the PPPoE connection is
established and
authenticated using an encrypted password. Which technology,
in combination with PPPoE, can be
used for authentication in this
manner?
A. PAP
B. dot1x
C. IPsec
D. CHAP
E. ESP
Answer:
D
NO.2 A network engineer is configuring SNMP on network devices to
utilize one-way SNMP
notifications. However, the engineer is not concerned
with authentication or encryption. Which
command satisfies the requirements
of this scenario?
A. router(config)#snmp-server host 172.16.201.28 traps
version 2c CISCORO
B. router(config)#snmp-server host 172.16.201.28 informs
version 2c CISCORO
C. router(config)#snmp-server host 172.16.201.28 traps
version 3 auth CISCORO
D. router(config)#snmp-server host 172.16.201.28
informs version 3 auth CISCORO
Answer: A
NO.3 Which two actions must
you perform to enable and use window scaling on a router? (Choose
two.)
A.
Execute the command ip tcp window-size 65536.
B. Set window scaling to be
used on the remote host.
C. Execute the command ip tcp queuemax.
D. Set
TCP options to "enabled" on the remote host.
E. Execute the command ip tcp
adjust-mss.
Answer: A,B
NO.4 After you review the output of the
command show ipv6 interface brief, you see that several
IPv6 addresses have
the 16-bit hexadecimal value of "FFFE" inserted into the address. Based on
this
information, what do you conclude about these IPv6 addresses?
A. IEEE
EUI-64 was implemented when assigning IPv6 addresses on the device.
B. The
addresses were misconfigured and will not function as intended.
C. IPv6
addresses containing "FFFE" indicate that the address is reserved for
multicast.
D. The IPv6 universal/local flag (bit 7) was flipped.
E. IPv6
unicast forwarding was enabled, but IPv6 Cisco Express Forwarding was
disabled.
Answer: A
NO.5 Which protocol uses dynamic address mapping
to request the next-hop protocol address for a
specific connection?
A.
Frame Relay inverse ARP
B. static DLCI mapping
C. Frame Relay broadcast
queue
D. dynamic DLCI mapping
Answer: A
NO.6 A network engineer
executes the show ip flow export command. Which line in the output
indicates
that the send queue is full and export packets are not being sent?
A. output
drops
B. enqueuing for the RP
C. fragmentation failures
D. adjacency
issues
Answer: A
NO.7 Refer to the following access
list.
access-list 100 permit ip any any log
After applying the access list
on a Cisco router, the network engineer notices that the router
CPU
utilization has risen to 99 percent. What is the reason for this?
A. A
packet that matches access-list with the "log" keyword is Cisco Express
Forwarding switched.
B. A packet that matches access-list with the "log"
keyword is fast switched.
C. A packet that matches access-list with the "log"
keyword is process switched.
D. A large amount of IP traffic is being
permitted on the router.
Answer: C
NO.8 An organization decides to
implement NetFlow on its network to monitor the fluctuation of
traffic that
is disrupting core services. After reviewing the output of NetFlow, the network
engineer is
unable to see OUT traffic on the interfaces. What can you
determine based on this information?
A. Cisco Express Forwarding has not been
configured globally.
B. NetFlow output has been filtered by default.
C.
Flow Export version 9 is in use.
D. The command ip flow-capture
fragment-offset has been enabled.
Answer: A
established and
authenticated using an encrypted password. Which technology,
in combination with PPPoE, can be
used for authentication in this
manner?
A. PAP
B. dot1x
C. IPsec
D. CHAP
E. ESP
Answer:
D
NO.2 A network engineer is configuring SNMP on network devices to
utilize one-way SNMP
notifications. However, the engineer is not concerned
with authentication or encryption. Which
command satisfies the requirements
of this scenario?
A. router(config)#snmp-server host 172.16.201.28 traps
version 2c CISCORO
B. router(config)#snmp-server host 172.16.201.28 informs
version 2c CISCORO
C. router(config)#snmp-server host 172.16.201.28 traps
version 3 auth CISCORO
D. router(config)#snmp-server host 172.16.201.28
informs version 3 auth CISCORO
Answer: A
NO.3 Which two actions must
you perform to enable and use window scaling on a router? (Choose
two.)
A.
Execute the command ip tcp window-size 65536.
B. Set window scaling to be
used on the remote host.
C. Execute the command ip tcp queuemax.
D. Set
TCP options to "enabled" on the remote host.
E. Execute the command ip tcp
adjust-mss.
Answer: A,B
NO.4 After you review the output of the
command show ipv6 interface brief, you see that several
IPv6 addresses have
the 16-bit hexadecimal value of "FFFE" inserted into the address. Based on
this
information, what do you conclude about these IPv6 addresses?
A. IEEE
EUI-64 was implemented when assigning IPv6 addresses on the device.
B. The
addresses were misconfigured and will not function as intended.
C. IPv6
addresses containing "FFFE" indicate that the address is reserved for
multicast.
D. The IPv6 universal/local flag (bit 7) was flipped.
E. IPv6
unicast forwarding was enabled, but IPv6 Cisco Express Forwarding was
disabled.
Answer: A
NO.5 Which protocol uses dynamic address mapping
to request the next-hop protocol address for a
specific connection?
A.
Frame Relay inverse ARP
B. static DLCI mapping
C. Frame Relay broadcast
queue
D. dynamic DLCI mapping
Answer: A
NO.6 A network engineer
executes the show ip flow export command. Which line in the output
indicates
that the send queue is full and export packets are not being sent?
A. output
drops
B. enqueuing for the RP
C. fragmentation failures
D. adjacency
issues
Answer: A
NO.7 Refer to the following access
list.
access-list 100 permit ip any any log
After applying the access list
on a Cisco router, the network engineer notices that the router
CPU
utilization has risen to 99 percent. What is the reason for this?
A. A
packet that matches access-list with the "log" keyword is Cisco Express
Forwarding switched.
B. A packet that matches access-list with the "log"
keyword is fast switched.
C. A packet that matches access-list with the "log"
keyword is process switched.
D. A large amount of IP traffic is being
permitted on the router.
Answer: C
NO.8 An organization decides to
implement NetFlow on its network to monitor the fluctuation of
traffic that
is disrupting core services. After reviewing the output of NetFlow, the network
engineer is
unable to see OUT traffic on the interfaces. What can you
determine based on this information?
A. Cisco Express Forwarding has not been
configured globally.
B. NetFlow output has been filtered by default.
C.
Flow Export version 9 is in use.
D. The command ip flow-capture
fragment-offset has been enabled.
Answer: A