Juniper JN0-303 덤프로 Juniper JN0-303 시험을 패스,하지 못하셨다구요? 최선을 다했는데도 실패하였다는 말은 영원히 하지마세요. Juniper JN0-303 시험을 패스하는 방법은 많고도 많습니다. Pass4Test의 Juniper JN0-303 덤프로 시험에 다시 도전해보세요. Pass4Test의 Juniper JN0-303 덤프는 착한 가격에 100%에 달하는 적중율과 패스율을 보장해드립니다. 시험에서 불합격성적표를 받으시면 덤프구매시 지불한 덤프비용을 환불처리해드립니다. Pass4Test의 Juniper JN0-303 덤프로 시험패스를 꿈꿔보세요.
NO.1 What are three examples of a provider-provisioned VPN supported by JUNOS software? (Choose
three.)
A. L2F
B. PPTP
C. Circuit cross-connect
D. Draft-Martini-based VPNs
E. Draft-Kompella-based VPNs
Answer: CDE
NO.2 Which LSA is the Type 10?
A. Router LSA
B. Opaque LSA
C. AS attributes LSA
D. ASBR summary LSA
E. Network summary LSA
Answer: B
NO.3 Which two steps are required for a Kompella Layer 2 VPN? (Choose two.)
A. Configure a site ID for each CE
B. Configure a VPN label for each VPN
C. Configure a MP-BGP session to each PE
D. Configure an Extended LDP Session to each PE
Answer: AC
NO.4 What are two commands that can be used to configure MBGP for multicast? (choose two)
A. Under the BGP group, configure family inet any
B. Use the set protocol MBGP command to enable MBGP
C. Under the BGP group, configure family inet multicast
D. Use the set rib-group command to copy the multicast routes into inet.1
Answer: AC
NO.5 What is the administrative scoping address range associated with global scope?
A. 224.0.0.0/24
B. 239.128.0.0/10
C. 239.192.0.0/14
D. 224.0.1.0?38.255.255.255
Answer: D
NO.6 An OSPF non-backbone area allows external routes to be flooded within the area. These external
routes are
propagated into other areas. However, external routes from other areas are not allowed to enter this area.
Which type of
OSPF area does this describe?
A. stub area
B. transit area
C. border area
D. not-so-stubby area
Answer: D
NO.7 Which multicast mode does Auto-RP require?
A. Link-mode
B. Dense mode
C. Sparse mode D. Sparse-dense mode
Answer: D
NO.8 What prevents routing loops when MSDP is configured across multiple domains?
A. PIM-SM
B. Scoping
C. Auto-RP
D. MBGP
Answer: D