NO.1 What occurs on a Frame Relay network when the CIR is exceeded?
A. All UDP traffic is marked discard eligible and a BECN is sent.
B. All TCP traffic is marked discard eligible.
C. All TCP traffic is marked discard eligible and a BECN is sent.
D. All traffic exceeding the CIR is marked discard eligible.
Answer: D
Explanation:
Committed information rate (CIR): The minimum guaranteed data transfer rate agreed to by the
Frame Relay switch. Frames that are sent in excess of the CIR are marked as discard eligible (DE)
which means they can be dropped if the congestion occurs within the Frame Relay network. Note: In
the Frame Relay frame format, there is a bit called Discard eligible (DE) bit that is used to identify
frames that are first to be dropped when the CIR is exceeded.
NO.2 Which parameter or parameters are used to calculate OSPF cost in Cisco routers?
A. Bandwidth, Delay, and MTU
B. Bandwidth
C. Bandwidth, MTU, Reliability, Delay, and Load
D. Bandwidth and Delay
Answer: B
200-105시험후기
Explanation:
http://www.cisco.com/en/US/tech/tk365/technologies_white_paper09186a0080094e9e.sht ml#t6
OSPF Cost
The cost (also called metric) of an interface in OSPF is an indication of the overhead required to send
packets across a certain interface. The cost of an interface is inversely proportional to the bandwidth
of that interface. A higher bandwidth indicates a lower cost.
There is more overhead (higher cost) and time delays involved in crossing a 56k serial line than
crossing a 10M Ethernet line. The formula used to calculate the cost is: Cost= 10000 0000/bandwidth
in bps
For example, it will cost 10 EXP8/10 EXP7 = 10 to cross a 10M Ethernet line and will cost 10
EXP8/1544000 =64 to cross a T1 line. By default, the cost of an interface is calculated based on the
bandwidth; you can force the cost of an interface with the ip ospf cost <value> interface sub
configuration mode command.
NO.3 Refer to the exhibit.
If the router R1 returns the given output and has not had its router ID set manually, what address will
EIGRP use as its router ID?
A. 192.168.1.2
B. 192.168.10.2
C. 172.16.4.1
D. 1.1.1.1
Answer: D
200-105 IT덤프
Explanation:
The router ID is selected according to the following rules: manual configuration highest up/up
loopback highest up/up physical interface
---
NO.4 Which term describes a spanning-tree network that has all switch ports in either the blocking or
fowarding state?
A. redundant
B. provisioned
C. spanned
D. converged
Answer: D
200-105자료 200-105덤프
Explanation:
Spanning Tree Protocol convergence (Layer 2 convergence) happens when bridges and switches have
transitioned to either the forwarding or blocking state. When layer 2 is converged, root bridge is
elected and all port roles (Root, Designated and Non-Designated) in all switches are selected.

Pass4Test의 Cisco인증 200-105최신덤프는 거의 모든 실제시험문제 범위를 커버하고 있습니다.Cisco인증 200-105최신덤프를 구매하여 덤프문제로 시험에서 불합격성적표를 받을시Pass4Test에서는 덤프비용 전액 환불을 약속드립니다.

Cisco인증 200-125시험후기을 통과하여 자격증을 취득하여 IT 업계에서의 자신의 자리를 지키려면 많은 노력이 필요합니다. 회사일도 바쁜데 시험공부까지 스트레스가 장난아니게 싸이고 몸도 많이 상하겠죠. Pass4Test는 여러분을 위해 최신Cisco인증 200-125시험후기에 대비한Cisco인증 200-125시험후기를 발췌하였습니다. Cisco인증 200-125시험후기는Cisco인증 200-125시험후기의 기출문제와 예상문제가 묶어져 있어 시험적중율이 굉장히 높습니다. 쉽게 시험을 통과하려면Pass4Test의 Cisco인증 200-125시험후기를 추천합니다.

시험 번호/코드: 200-105
시험 이름: Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0)
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 200-105최신덤프
PDF 및 소프트웨어, 연구와 실천

>>200-105자격증신청

시험 번호/코드: 200-125
시험 이름: CCNA Cisco Certified Network Associate CCNA (v3.0)
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 200-125시험후기
PDF 및 소프트웨어, 연구와 실천

>>200-125 Dumps

Pass4Test의Cisco인증 200-105최신덤프를 공부하시면 한방에 시험을 패스하는건 문제가 아닙니다. Pass4Test의Cisco인증 200-105최신덤프는 시험적중율 최고의 인지도를 넓히 알리고 있습니다.저희가 제공한 시험예상문제로 시험에 도전해보지 않으실래요? Cisco인증 200-105최신덤프를 선택하시면 성공의 지름길이 눈앞에 다가옵니다.

200-105 덤프무료샘플다운로드하기: http://www.pass4test.net/200-105.html