Cisco CCIE Data Center 350-080시험을 패스하여 자격증을 취득하는게 꿈이라구요? Pass4Test에서 고객님의  Cisco CCIE Data Center 350-080시험패스꿈을 이루어지게 지켜드립니다. Pass4Test의 Cisco CCIE Data Center 350-080덤프는 가장 최신시험에 대비하여 만들어진 공부자료로서 시험패스는 한방에 끝내줍니다.

The exam is closed book, and no outside reference materials are allowed. The following topics are general guidelines for the content that is likely to be included on the exam. However, other related topics may also appear on any specific delivery of the exam. In order to better reflect the contents of the exam and for clarity purposes, the guidelines that follow may change at any time without notice.

NO.1 Refer to the exhibit.
Which two options describe information that can be determined from this output? (Choose two.)
A. the uplink interface that is operating as the designated receiver for broadcast traffic
B. the uplink interface that is operating as the designated sender for broadcast traffic
C. the switching mode for which the Fabric Interconnect is configured
D. the uplink interface from which multicast traffic will be sourced
E. whether the last respond code was accepted or not
Answer: A,C

NO.2 Enabling jumbo frame support on a Cisco Nexus 5500 Switch can be done through which
method?
A. Changing the default policy map from a default MTU of 1500 to 9216
B. Using the command system jumbomtu 9216
C. Using the command interface MTU 9216
D. Configuring the default Ethernet system class to an MTU of 9216 with a new network QoS policy
map
Answer: D

NO.3 How many concurrent GUI logins are possible per user account on Cisco UCS Manager?
A. 128
B. 96
C. 64
D. 32
Answer: D

NO.4 FabricPath brings the benefits of routing protocols to Layer 2 network Ethernet
environments. Which thee options describe advantages of using FabricPath technology? (Choose
three.)
A. MAC address scalability with conversational learning
B. loop mitigation with TTL in the frame field
C. Spanning Tree Protocol independence
D. 10-Gb/s bandwidth
E. Layer 2 extensions between data centers
Answer: A,B,C

NO.5 In one-armed design, which method must be used to achieve symmetric load balancing in
ACE?
A. Dual NAT
B. Round Robin
C. Dynamic Routing Protocol
D. MAC Probe
Answer: A

NO.6 Traffic drop for FCoE is experienced across a Nexus 5548 switch. What is a possible cause?
A. Server's CNA does not support DCBX and PFC TLV was not negotiated.
B. A "no-drop" class has not been configured for FCoE.
C. The system is running with the default QOS policies.
D. The link is oversubscribed.
Answer: A

NO.7 Refer to the exhibit.
The interface remains in a down state after entering the command that is shown in the exhibit. What
is the cause of the problem?
A. The feature interface-vlan command must be configured.
B. The VDC contains only F1 interfaces.
C. There are IP address conflicts.
D. The VDC is "type OTV."
E. The command copy run start was not entered.
Answer: B

NO.8 Basic zoning changes are accomplished through the use of four SW_ILS frames. Which option
identifies these frames in the correct order?
A. RCA, UFC, SFC, ACA
B. ACA, RCA, SFC, UFC
C. SFC, UFC, ACA, RCA
D. ACA, SFC, UFC, RCA
E. UFC, SFC, RCA, ACA
Answer: D