많은 사이트에서 VMware Certification VCI510 인증시험대비자료를 제공하고 있습니다. 그중에서 Pass4Test를 선택한 분들은 VMware Certification VCI510 시험통과의 지름길에 오른것과 같습니다. Pass4Test는 시험에서 불합격성적표를 받으시면 덤프비용을 환불하는 서비스를 제공해드려 아무런 걱정없이 시험에 도전하도록 힘이 되어드립니다. Pass4Test덤프를 사용하여 시험에서 통과하신 분이 전해주신 희소식이 Pass4Test 덤프품질을 증명해드립니다.
NO.1 An administrator is installing ESXi on several hosts attached to iSCSI
storage.
Why would the administrator detach the host from the IP storage
network prior to installation?
A. It decreases the time the installer needs
to search for available disk drives.
B. It allows the installation of a
generic VAAI component for IP storage.
C. It prevents ESXi from installing
vSphere Flash Cache to the IP storage.
D. It is required when installing ESXi
onto a physical server that utilizes IP storage.
Answer: A
NO.2 What
two IT infrastructure components are virtualized by vSphere Essentials? (Choose
two.)
A. Networks
B. Applications
C. Storage
D.
Management
Answer: A,C
NO.3 A vSphere administrator is attempting to
migrate a virtual machine, but the progress bar for the
migration remains at
10%.
Which issue could be preventing the vMotion migration?
A. A
networking problem between the source and destination hosts exists at the
physical layer.
B. The virtual machine is not on shared storage visible to
the source and destination hosts.
C. The vMotion migration priority for this
migration was set to High.
D. The vMotion network is saturated.
Answer:
A
NO.4 A VMware administrator determines that a low priority virtual
machine is negatively affecting
the disk I/O performance of a higher priority
virtual machine. The virtual machines are hosted on the
same datastore
presented to the same ESXi host.
Which configuration option should the VMware
administrator use to resolve this issue?
A. Increase the disk share value for
the high priority VM.
B. Migrate the low priority VM to another ESXi
host.
C. Create a Storage Profile for each priority level.
D. Enable
vSphere APIs for Array Integration (VAAI).
Answer: A
NO.5 A vSphere
administrator manages a three host cluster with 20 VMs. The HA cluster
is
configured with the Host Failures the Cluster Tolerates admission control
policy and all other settings
are set to default values. The administrator
determines that one of the VMs is not able to power on.
After further
inspection, it is determined that this VM cannot power on because of a very
large CPU
reservation.
Which cluster advanced HA setting can the
administrator modify to enable the virtual machine to
power on?
A. Lower
das.vmcpumaxmhz attribute value
B. Higher das.vmcpuminmhz attribute
value
C. Lower das.slotcpuoutmhz attribute value
D. Higher
das.slotcpuinmhz attribute value
Answer: D
NO.6 Which controller is
recommended for high disk I/O workloads?
A. BusLogic Parallel
B. LSI Logic
Parallel
C. LSI Logic SAS
D. VMware Paravirtual
Answer: D
NO.7
What should an administrator do to configure multi-pathing using software
iSCSI?
A. Bind the VMkernel ports to the software iSCSI initiator
B.
Configure Zoning between the hosts and SAN switches
C. Configure NIC teaming
on the associated uplinks
D. Ensure jumbo frames are enabled
end-to-end
Answer: A
NO.8 A SAN administrator recently installed a
storage encryption switch on the Fibre Channel Fabric.
Shortly after the
deployment, several new VMFS5 datastores recently created were
dismounted.
Attempts to manually mount them fail. VMFS5 upgraded datastores
are unaffected. All Storage
arrays in use support VASA and VAAI.
What is
the root cause of this problem?
A. All newly created VMFS5 datastores are
tagged ATS_Only. The storage encryption switch blocks
the ATS command.
B.
All newly created VMFS5 datastores are tagged XCOPY_Only. The storage encryption
switch blocks
the XCOPY command.
C. All newly created VMFS5 datastores are
tagged WRITE_SAME_Only. The storage encryption switch
blocks the WRITE_SAME
command.
D. All newly created VMFS5 datastores were formatted with 1MB block
size. The storage encryption
switch does not support this block
size.
Answer: A
storage.
Why would the administrator detach the host from the IP storage
network prior to installation?
A. It decreases the time the installer needs
to search for available disk drives.
B. It allows the installation of a
generic VAAI component for IP storage.
C. It prevents ESXi from installing
vSphere Flash Cache to the IP storage.
D. It is required when installing ESXi
onto a physical server that utilizes IP storage.
Answer: A
NO.2 What
two IT infrastructure components are virtualized by vSphere Essentials? (Choose
two.)
A. Networks
B. Applications
C. Storage
D.
Management
Answer: A,C
NO.3 A vSphere administrator is attempting to
migrate a virtual machine, but the progress bar for the
migration remains at
10%.
Which issue could be preventing the vMotion migration?
A. A
networking problem between the source and destination hosts exists at the
physical layer.
B. The virtual machine is not on shared storage visible to
the source and destination hosts.
C. The vMotion migration priority for this
migration was set to High.
D. The vMotion network is saturated.
Answer:
A
NO.4 A VMware administrator determines that a low priority virtual
machine is negatively affecting
the disk I/O performance of a higher priority
virtual machine. The virtual machines are hosted on the
same datastore
presented to the same ESXi host.
Which configuration option should the VMware
administrator use to resolve this issue?
A. Increase the disk share value for
the high priority VM.
B. Migrate the low priority VM to another ESXi
host.
C. Create a Storage Profile for each priority level.
D. Enable
vSphere APIs for Array Integration (VAAI).
Answer: A
NO.5 A vSphere
administrator manages a three host cluster with 20 VMs. The HA cluster
is
configured with the Host Failures the Cluster Tolerates admission control
policy and all other settings
are set to default values. The administrator
determines that one of the VMs is not able to power on.
After further
inspection, it is determined that this VM cannot power on because of a very
large CPU
reservation.
Which cluster advanced HA setting can the
administrator modify to enable the virtual machine to
power on?
A. Lower
das.vmcpumaxmhz attribute value
B. Higher das.vmcpuminmhz attribute
value
C. Lower das.slotcpuoutmhz attribute value
D. Higher
das.slotcpuinmhz attribute value
Answer: D
NO.6 Which controller is
recommended for high disk I/O workloads?
A. BusLogic Parallel
B. LSI Logic
Parallel
C. LSI Logic SAS
D. VMware Paravirtual
Answer: D
NO.7
What should an administrator do to configure multi-pathing using software
iSCSI?
A. Bind the VMkernel ports to the software iSCSI initiator
B.
Configure Zoning between the hosts and SAN switches
C. Configure NIC teaming
on the associated uplinks
D. Ensure jumbo frames are enabled
end-to-end
Answer: A
NO.8 A SAN administrator recently installed a
storage encryption switch on the Fibre Channel Fabric.
Shortly after the
deployment, several new VMFS5 datastores recently created were
dismounted.
Attempts to manually mount them fail. VMFS5 upgraded datastores
are unaffected. All Storage
arrays in use support VASA and VAAI.
What is
the root cause of this problem?
A. All newly created VMFS5 datastores are
tagged ATS_Only. The storage encryption switch blocks
the ATS command.
B.
All newly created VMFS5 datastores are tagged XCOPY_Only. The storage encryption
switch blocks
the XCOPY command.
C. All newly created VMFS5 datastores are
tagged WRITE_SAME_Only. The storage encryption switch
blocks the WRITE_SAME
command.
D. All newly created VMFS5 datastores were formatted with 1MB block
size. The storage encryption
switch does not support this block
size.
Answer: A