Pass4Test의 Cisco 400-101 (CCIE Routing and Switching Written Exam)덤프를 구매하여 공부한지 일주일만에 바로 시험을 보았는데 고득점으로 시험을 패스했습니다.이는Pass4Test의 Cisco 400-101 (CCIE Routing and Switching Written Exam)덤프를 구매한 분이 전해온 희소식입니다. 다른 자료 필요없이 단지 저희  Cisco 400-101 (CCIE Routing and Switching Written Exam)덤프로 이렇게 어려운 시험을 일주일만에 패스하고 자격증을 취득할수 있습니다.덤프가격도 다른 사이트보다 만만하여 부담없이 덤프마련이 가능합니다.구매전 무료샘플을 다운받아 보시면 믿음을 느낄것입니다.

NO.1 Which circumstance can cause packet loss due to a microburst?
A. slow convergence
B. a blocked spanning-tree port
C. process switching
D. insufficient buffers
Answer: D

NO.2 Refer to the exhibit.
Which statement is true?
A. R1 routes this pseudowire over MPLS TE tunnel 1 with transport label 20.
B. The default route 0.0.0.0/0 is available in the IPv4 routing table.
C. R1 is using an MPLS TE tunnel for this pseudowire, because the IP path is not available .
D. R1 has preferred-path configured for the pseudowire.
Answer: D

NO.3 Which three statements are functions that are performed by IKE phase 1? (Choose three.)
A. It builds a secure tunnel to negotiate IKE phase 1 parameters.
B. It establishes IPsec security associations.
C. It authenticates the identities of the IPsec peers.
D. It protects the IKE exchange by negotiating a matching IKE SA policy.
E. It protects the identities of IPsec peers.
F. It negotiates IPsec SA parameters.
Answer: C,D,E

NO.4 Refer to the exhibit.
Which statement is true?
A. IS-IS has been enabled on R4 for IPv6, single-topology.
B. IS-IS has been enabled on R4 for IPv6, multitopology.
C. IS-IS has been enabled on R4 for IPv6, single-topology and multitopology.
D. R4 advertises IPv6 prefixes, but it does not forward IPv6 traffic, because the protocol has not been
enabled under router IS-IS.
Answer: A

NO.5 Which two options are causes of out-of-order packets? (Choose two.)
A. a routing loop
B. a router in the packet flow path that is intermittently dropping packets
C. high latency
D. packets in a flow traversing multiple paths through the network
E. some packets in a flow being process-switched and others being interrupt-switched on a
transit router
Answer: D,E

NO.6 Which attribute is not part of the BGP extended community when a PE creates a VPN-IPv4
route while running OSPF between PE-CE?
A. OSPF domain identifier
B. OSPF route type
C. OSPF router ID
D. MED
E. OSPF network type
Answer: E

NO.7 Which two statements about the function of the stub feature in EIGRP are true? (Choose two.)
A. It stops the stub router from sending queries to peers.
B. It stops the hub router from sending queries to the stub router.
C. It stops the stub router from propagating dynamically learned EIGRP prefixes to the hub routers.
D. It stops the hub router from propagating dynamically learned EIGRP prefixes to the stub routers.
Answer: B,C

NO.8 Which statement is true regarding UDLD and STP timers?
A. The UDLD message timer should be two times the STP forward delay to prevent loops.
B. UDLD and STP are unrelated features, and there is no relation between the timers.
C. The timers need to be synced by using the spanning-tree udld-sync command.
D. The timers should be set in such a way that UDLD is detected before the STP forward delay
expires.
Answer: D