인테넷에 검색하면 IBM Certifed Systems Expert A4040-221시험덤프공부자료가 헤아릴수 없을 정도로 많이 검색됩니다. 그중에서 Pass4Test의 IBM Certifed Systems Expert A4040-221제품이 인지도가 가장 높고 가장 안전하게 IBM Certifed Systems Expert A4040-221시험을 패스하도록 지름길이 되어드릴수 있습니다.
NO.1 What is the difference between deferred and concurrent firmware updates?
A. Deferred firmware can be applied concurrently but contains updates that affect the internal
program load path, which are not activated until the next time the server is shut down and restarted.
B. Concurrent firmware must be done on all LPARs in the frame at the same time. Deferred
firmware can be loaded on each LPAR at a different time and only becomes active when the LPAR is
shutdown and restarted.
C. Deferred firmware can only be applied during an outage to the managed system as it will
automatically shut the managed system down during its installation.
D. Concurrent firmware is only for minor fixes to the system mircocode while deferred firmware
contains major fixes to the service processor.
Answer: A
NO.2 An LPAR is configured with strict logical volume mirroring across two disks for resilience. The
administrator would like to ensure if one disk fails the volume group stays online. Which command
will ensure that the datavg volume group stays online?
A. varyonvg -n datavg
B. mirrorvg-Q-c 2 datavg
C. mklvcopy -e m -s y (each logical volume name) 2
D. chvg -Qn datavg
Answer: D
NO.3 How can an administrator disable Role Based Access Control (RBAC) in a WPAR?
A. Run chattr -E -I sys0 -a enhanced_RBAC=false Reboot the WPAR
B. Run the RBAC wizard and deselect 'Enable RBAC Reboot the system
C. Run chdev -I mywpar -a enhanced_RBAC=false Reboot the Global Environment
D. Run chwpar -a RBAC=false Reboot the WPAR
Answer: C
NO.4 The following information has been reported in an AIX error log:
How can the administrator prevent the error from reoccurring?
A. Create a secondary dump device greater than 266MB
B. Increase primary dump device size greater than 266MB
C. Increase "/var" file system to ensure it has a minimum of 266MB free space
D. Increase "/var/adm/ras/livedump" file system to ensure it has a minimum of 266MB free space
Answer: C
NO.5 After performing a NIM rte install, the administrator noticed that not all filesets are at the
correct Technology Level (TL). What action will help the administrator determine why the
inconsistent fileset levels were installed?
A. On the NIM server, run an Ippchk to identify if the Software Vital Product Data is valid.
B. On the NIM client, run oslevel command against the TL to identify missing prerequisites.
C. Run instfix command on NIM client to determine what filesets are inconsistent.
D. On the NIM server run the NIM IsIpp command to indentify downlevel filesets contained in the
lpp_source.
Answer: D
NO.6 What is a requirement for Live Partition Mobility?
A. The network and disk must be virtual.
B. The disk must be virtual and a Logical Host Ethernet Adapter (LHEA) for network.
C. The client partition must be connected to a SAN.
D. The client partition must be set up as a 'Mover Service Partition'.
Answer: A
NO.7 A host has a single virtual Ethernet adapter (ent0) configured with only a default PVID, and the
administrator is trying to determine why it cannot be used to reach any other system on the
network. He suspects that it may be caused by a problem in the VLAN configuration.
How would the administrator determine the VLAN for which the adapter was configured?
A. Use the command 'Isdev -I ent0' on the host to determine the port VLAN ID.
B. Use the command 'Isattr-EI ent0' on the host to determine the port VLAN ID.
C. Look on the HMC to determine which VLAN is configured for the adapter.
D. Examine the Shared Ethernet Adapter on the Virtual I/O Server to determine which VLAN the
adapter is using.
Answer: C
NO.8 Which technology provides the maximum amount of usable storage and resilience for a
system with 6 physical volumes?
A. RAID 0
B. RAID 1
C. RAID 5
D. RAID 6
Answer: C