IT인증,IT자격증,IT자격증시험,IT인증시험

http://www.pass4test.net/

CCSA 156-215.71 (Check Point Certified Security Administrator R71) 덤프

CCSA 156-215.71 (Check Point Certified Security Administrator R71)  시험을 패스하여 자격증을  취득하시면 찬란한 미래가 찾아올것입니다. CCSA 156-215.71 (Check Point Certified Security Administrator R71) 인증시험을 패스하여 취득한 자격증은 IT인사로서의 능력을 증명해주며 IT업계에 종사하는 일원으로서의 자존심입니다. Pass4Test 의 CCSA 156-215.71 (Check Point Certified Security Administrator R71) 덤프는 시험패스에 초점을 맞추어 제일 간단한 방법으로 시험을 패스하도록 밀어주는 시험공부가이드입니다.구매전  CCSA 156-215.71 (Check Point Certified Security Administrator R71) 무료샘플을 다운받아 적성에 맞는지 확인하고 구매할지 않할지 선택하시면 됩니다.

 

NO.1 Which answers are TRUE? Automatic Static NAT CANNOT be used when:
i) NAT decision is based on the destination port
ii) Source and Destination IP both have to be translated
iii) The NAT rule should only be installed on a dedicated Gateway only
iv) NAT should be performed on the server side
A.(i), (ii), and (iii)
B.(i), and (ii)
C.ii) and (iv)
D.only (i)
Answer: D

NO.2 For which service is it NOT possible to configure user authentication?
A.HTTPS
B.FTP
C.SSH
D.Telnet
Answer: C

NO.3 When configuring the network interfaces of a checkpoint Gateway, the direction can be defined as
Internal or external.
What is meaning of interface leading to DMZ?
A.It defines the DMZ Interface since this information is necessary for Content Control.
B.Using restricted Gateways, this option automatically turns off the counting of IP Addresses originating
from this interface
C.When selecting this option.Ann-Spoofing is configured automatically to this net.
D.Activating this option automatically turns this interface to External
Answer: A

NO.4 IPS Profiles

NO.5 Secure Platform WebUI Users

NO.6 Security Gateway R71 supports User Authentication for which of the following services? Select the
response below that contains the most complete list of supported services.
A.FTP, HTTP, TELNET
B.FTP, TELNET
C.SMTP, FTP, HTTP, TELNET
D.SMTP, FTP, TELNET
Answer: A

NO.7 Gateway route table

NO.8 If you check the box Use Aggressive Mode in the IKE Properties dialog box, the standard:
A.three-packet IKE Phase 2 exchange Is replaced by a six-packet exchange
B.three-packet IKE Phase 2 exchange is replaced by a two-packet exchange
C.six-packet IKE Phase 1 exchange is replaced by a three-packet exchange
D.three-packet IKE Phase 1 exchange is replaced by a six-packet exchange
Answer: C

Posted 2014/5/21 10:17:17  |  Category: CheckPoint  |  Tag: CCSA 156-215.71