IT인증,IT자격증,IT자격증시험,IT인증시험

http://www.pass4test.net/

Cisco 642-980 (Troubleshooting Cisco Data Center Unified Fabric (DCUFT))덤프

Cisco 642-980 (Troubleshooting Cisco Data Center Unified Fabric (DCUFT)) 시험에 도전해보려고 없는 시간도 짜내고 거금을 들여 학원을 선택하셨나요? 사실 IT인증시험은 보다 간단한 공부방식으로 준비하시면 시간도 돈도 정력도 적게 들일수 있습니다. 그 방법은 바로 Pass4Test의 Cisco 642-980 (Troubleshooting Cisco Data Center Unified Fabric (DCUFT)) 시험준비덤프자료를 구매하여 공부하는 것입니다. 문항수도 적고 시험예상문제만 톡톡 집어 정리된 덤프라 시험합격이 한결 쉬워집니다.



NO.1 There is an ARP storm in VDC 1. Some users on VDC 2 notice that ARP is not resolving for their
gateways on the Cisco Nexus core. What is the cause?
A. The ARP traffic in VDC 1 is copied to the host ports in VDC 2,causing overutilization and output
discards.
B. Because the ARP process in the default VDC (VDC 1) is responsible for processing ARPtraffic
for all VDCs, VDC 2 will be affected.
C. The administrator has not correctly configured the ARP CoPP class in VDC 2.
D. The ARP CoPP class committed information rate is exceeded, resulting in ARP lossin all VDCs.
Answer: D

NO.2 Which command would you use to find the AED of an extended VLAN in a dual-homed site of
an
OTV network?
A. show otv aed on the AED
B. show otvvlan on any edge devices in the site
C. show otv vlan on the AED
D. show otvaed on any edge devices in the site
E. show otv site on any edge devices in the site
Answer: C

NO.3 Which command is used to check for potential vPC configuration consistency problems?
A. showvpc brief interface
B. show vpc global config
C. show vpc consistency-parameters global
D. showvpc config
Answer: C

NO.4 A customer is deploying multihop FCoE in its network. Which guideline must the customer
follow
with respect to VE ports to make this deployment possible?
A. VE-port interface binding to MAC addresses is supported.
B. AVE port is disabled for trunk mode by default.
C. Auto mode on the vFC interface is supported.
D. VE-port trunking is supported over FCoE-enabled VLANs.
Answer: D

NO.5 A customer is troubleshooting FCoE in its network. They have discovered that vFC is currently
down and there is no active STP port state on the bound Ethernet interface. What should the STP
port state be to correct this issue?
A. The bound interface should be in an STP forwarding state for both the native VLANand the
member FCoE VLAN that is mapped to the active VSAN.
B. The bound interface should be in an STP blocking state for both the native VLANand the
member FCoE VLAN that is mapped to the active VSAN.
C. The bound interface should be in an STP learning state for both the native VLANand the
member FCoE VLAN that is mapped to the active VSAN.
D. The bound interface should be in an STP forwarding state for the native VLAN only.
Answer: A

NO.6 Which statement is true regarding FHRP considerations for an OTV network?
A. Filtering FHRP across the OTV network is recommended to avoid a suboptional path due to the
election of a single default gateway.
B. Using an AED eliminates the need for FHRP .
C. VRRP is recommended over HSRP or GLBP .
D. FHRP should be limited to only the internal OTV interfaces.
Answer: A

NO.7 You customer is an ISP providing service to thousands of end customers. Its main concern are
focused on using up the total number of 4096 VLANs per VDC, wasting an unused block of IP
addresses, and IP address management. Which technique will address these concerns?
A. create mapping between the VLAN and VSAN to run FCoE to consolidate VLAN and IP
address
B. segment VLANs using secondary IP addresses, which will reduce the management domain
C. create a separate VDC to scale VLAN limitation and upgrade to Cisco Nexus 7018 Switch
D. use PVLANs,which will solve the scalability problem and provide IP address management
Answer: D

Posted 2014/5/4 16:50:15  |  Category: cisco  |  Tag: Cisco 642-980