Pass4Test는 여러분이 원하는 최신 최고버전의 Cisco 350-040 (CCIE Storage Networking) 덤프를 제공합니다. Cisco 350-040 (CCIE Storage Networking) 덤프는 IT업계전문가들이 끊임없는 노력과 지금까지의 경험으로 연구하여 만들어낸 제일 정확한 시험문제와 답들로 만들어졌습니다. Pass4Test의 문제집으로 여러분은 충분히 안전이 시험을 패스하실 수 있습니다. 우리 Pass4Test 의 문제집들은 모두 100%합격율을 자랑하며 Pass4Test의 제품을 구매하였다면 Cisco 350-040 (CCIE Storage Networking) 시험패스와 자격증 취득은 근심하지 않으셔도 됩니다. 여러분은 IT업계에서 또 한층 업그레이드 될것입니다.
NO.1 Can Cisco Fabric Services be used to distribute iSCSI initiator configurations?
A. yes
B. no
C. only when the SAN_EXTN_OVER_IP_18_4 license is installed on the switch
D. only when ENTERPRISE_PKG is installed on the switch
Answer: A
NO.2 Which three of these statements about the E_D_TOV are correct? (Choose three.)
A. It is a timer with a default value of 100 ms that is used by the receiver logic to detect loss of
synchronization.
B. It is a timer with a default value of two seconds that is used for detecting protocol error conditions.
C. It is a timer used as the timeout value for determining when to reinstate a Recovery_Qualifier.
D. During fabric login, it is negotiated by the N_Port and the fabric as one of the common service
parameters exchanged.
E. It represent a limit on the amount of time within which an action can be taken after the transmission of
consecutive data frames within a single sequence.
Answer: BDE
NO.3 What is the purpose of the Open Fiber Control system?
A. It defines the flow control mechanism for Fibre Channel.
B. It defines the mechanism by which Fibre Channel switches communicate with Gbics.
C. It defines a safety mechanism for shutting down laser data links.
D. It defines the distance limitations for different types of lasers.
E. It specifies the maximum bit error rate for Fibre Channel links.
Answer: C
NO.4 Which two of these statements about the R_T_TOV are true? (Choose two.)
A. It is a timer with a default value of 100 ms that is used by the receiver logic to detect loss of
synchronization.
B. It is a timer with a default value of 100 ms that it is used for detecting protocol error conditions.
C. Its values is two times that of E_D_TOV, and it is used as the timeout value for determining when to
reinstate a Recovery_Qualifier.
D. It is negotiated between the N_Port and the fabric during the fabric login as one of the common service
parameters exchanged.
E. It is used to time events occurring on a single link.
Answer: AE
NO.5 All of these are functions of LIP except which one?
A. reinitialize a loop
B. perform passive attachment to loop
C. indicate loop receiver failure
D. indicate which port to reset on loop
E. acquire an AL_PA
Answer: B
NO.6 What set of primitive signals is valid for arbitrated loop?
A. NOS, LOS, LR, LRR
B. SOF, EOF, ABTS, ACK
C. LIFA, LIPA, LIHA, LISA
D. LIP, LR, LRR, SOF
E. CLS, OPN, ARB
Answer: E
NO.7 Which three of these are attributes of the 8B/10B encoding scheme used by Fibre Channel? (Choose
three.)
A. facilitates a sufficient number of one-to-zero transitions to enable clock recovery
B. maintains DC balance
C. detects all transmission errors
D. provides variable bit, byte, and word rates
E. generates special characters beyond the eight-bit code space
Answer: ABE
NO.8 What makes the R_CTL field valuable to Extended Link Services?
A. It uses hex'03' for all request frames and hex'02' for all reply frames.
B. It uses hex'02' for all request frames and hex'03' for all reply frames.
C. It uses hex'00' for all request frames and hex'01' for all reply frames.
D. It uses hex'02' for all request and reply frames (the ILS request and reply frames are not differentiated
by the R_CTL field).
E. It does not have a fixed value and the value depends on the specific Internal Link Service.
Answer: B
NO.9 In Cisco MDS, how is a pWWN assigned to a dynamically assigned iSCSI?
A. by the system
B. by the user in the configuration of the iSCSI target
C. by the iSCSI host
D. created with iSCSI host name, iSCSI driver, and Connection ID
E. by the storage system attached to Fibre Channel
Answer: A
NO.10 Which two of these are effects of a BF SW_ILS? (Choose two.)
A. It causes a disruptive reconfiguration of the fabric.
B. It causes a non-disruptive reconfiguration of the fabric.
C. It causes a new principal switch selection to happen.
D. It causes all the assigned addresses in the fabric to be changed, while avoiding traffic loss by holding
data traffic.
E. It helps to resolve overlapping domain identifiers.
Answer: BC
NO.11 Which two statements are true? (Choose two.)
A. Fabric logins are sent to destination FC-ID 0xFFFFFA.
B. Fabric logins are sent to destination FC-ID 0xFFFFFC.
C. FSPF HLO packets are sent from source FC-ID 0xFFFFFD.
D. FC-ID 0xFFFFFA is reserved for the management server.
E. Name server logins are sent to destination FC-ID 0xFFFFFD.
Answer: CD
NO.12 Is the iSNS client supported on VRRP interfaces?
A. yes
B. no
C. only when the storage_services_enabler_pkg license is enabled on the switch
D. only on Cisco IPS line cards
Answer: B
NO.13 What ordered set is used to determine the class of a frame?
A. COF
B. SYN
C. SOF
D. TYP
E. LIP
Answer: C
NO.14 Which configuration command enables all discovered storage to be available for iSCSI?
A. iscsi virtual-target all
B. iscsi target enable fc
C. fc-target import iscsi
D. enable fc targets dynamic
E. iscsi import target fc
Answer: E
NO.15 What is the function of the Link Reset Protocol within the Link Control Facility?
A. it is part of the LIP process
B. it is used only for Class 1 connection removal
C. it is used to arbitrate on loops to recover from loss of synchronization
D. it is used following a link failure and controls the NOS and LOS substates
E. it is used following a link timeout or connection error and controls the LR and LRR substates
Answer: E
NO.16 Which two events will trigger a port to start a Link Initialization Protocol procedure? (Choose two.)
A. the power is turned on
B. a LOGO ELS command is received
C. an internal reset is performed
D. an interface SHUT command is issued
E. an RSCN is received
Answer: AC
NO.17 What Fibre Channel transport functions can be found at the FC-2 level?
A. Exchange Operation, Information Unit, and Sequence
B. Session, Exchange, and Information Unit
C. Sequence, Frame, and Flow Control
D. Sequence, Frame, and Information Unit
E. Exchange Management, Link Control, and Flow Control
Answer: C
NO.18 During principal switch selection and domain ID assignment, all frames are flooded to a destination ID
of what well-known Fibre Channel address?
A. FF.FF.FA
B. FF.FF.FB
C. FF.FF.FC
D. FF.FF.FD
E. FF.FF.FE
Answer: D
NO.19 The Domain Identifier Assigned (DIA) SW_ILS command indicates which two of these? (Choose two.)
A. a principal switch has been selected and the upstream neighbor switch has been assigned a domain
identifier
B. the principal switch selection and address assignment phase has been completed and the fabric is
operational
C. the receiving switch can proceed to request a domain identifier
D. the principal switch selection has been started, but a principal switch has not been identified yet
E. a Request Domain Identifier SW_ILS frame has been received by the principal switch
Answer: AC
NO.20 The Class 2 class of service always uses end-to-end acknowledgments (ACK, BSY or RJT) for every
data frame. What else is true of Class 2?
A. It is an "unreliable" datagram service that does not guarantee fixed latency or in-order delivery.
B. It is a "reliable" datagram service that guarantees fixed latency and in-order delivery.
C. It is a "reliable" datagram service that does not guarantee fixed latency but guarantees in-order
delivery.
D. It is a "reliable" datagram service that does not guarantee fixed latency or in-order delivery.
Answer: D
NO.21 Refer to the exhibit. The fabric containing Switch A is merging with the fabric containing Switch B.
Which switch will become the principal switch, and why?
A. Switch A, because its principal switch priority value is lower
B. Switch B, because its principal switch priority value is higher
C. Switch A, because its principal switch WWN is lower
D. Switch B, because its principal switch WWN is higher
E. not enough information has been given
Answer: A
NO.22 Which of these TCP ports does iSNS use?
A. 3205
B. 3225
C. 3226
D. 3325
Answer: A
NO.23 What Fibre Channel header field indicates the frame is a Link Control frame?
A. R_CTL
B. CS_CTL
C. TYPE
D. F_CTL
E. DF_CTL
Answer: A
NO.24 Which three of these Fibre Channel words are known as primitive signals? (Choose three.)
A. NOS
B. R_RDY
C. CLS
D. LIP
E. IDLE
Answer: BCE
NO.25 What is the correct configuration to place initiator ABC.icq into VSANs 3 and 66 exclusively?
A. iscsi initiator name ABC.iqn
vsan 3 66
B. iscsi initiator name ABC.iqn
no vsan 1
vsan 3 - 66
C. iscsi initiator name ABC.iqn
no vsan 1
vsan 3
vsan 66
D. iscsi initiator name ABC.iqn
vsan member vsan 3
vsan 66
E. iscsi initiator name ABC.iqn
vsan member vsan 3,66
Answer: C
NO.26 What SW_ILS frame is used to perform principal switch selection?
A. RDI
B. DIA
C. EFP
D. ELP
E. ESC
Answer: C
NO.27 Fibre Channel Protocol is a protocol consisting of several layers. What are these layers, in order from
FC-0 to FC-4?
A. Media, Encode and Decode, Framing and Control, Common Services, Upper Level Protocol
B. Encode and Decode, Media, Framing and Control, Common Services, Upper Level Protocol
C. Framing and Control, Encode and Decode, Media, Common Services, Upper Level Protocol
D. Upper Level Protocol, Common Services, Framing and Control, Encode and Decode, Media
E. Media, Framing and Control, Encode and Decode, Common Services, Upper Level Protocol
Answer: A
NO.28 If a Fibre Channel interface is receiving an NOS pattern on its interface, what pattern will the interface
be transmitting?
A. OLS
B. LR
C. LRR
D. IDLE
E. NOS
Answer: A
NO.29 In which of these situations will a fabric zone merge failure occur between fabric A and fabric B?
A. the active zone sets in both fabric A and fabric B are an exact match before the merge is attempted
B. the active zone set in fabric A has more zones than the active zone set in fabric B
C. a zone in fabric A contains three members, while a zone with the same name in fabric B contains four
members
D. zone names used in fabric A are 10 characters, while the zone names in fabric B contain fewer than 10
characters
E. a zone name in fabric A is different from a zone name in fabric B but the zone members in the two
zones are the same
Answer: C
NO.30 Which of these is used to identify the special characters used in Fibre Channel encoding?
A. K28.5
B. 8B/10B
C. 3B/4B
D. D28.5
E. idle
Answer: A