인테넷에 검색하면  HP ExpertONE Certification HP0-J65시험덤프공부자료가 헤아릴수 없을 정도로 많이 검색됩니다. 그중에서 Pass4Test의   HP ExpertONE Certification HP0-J65제품이 인지도가 가장 높고 가장 안전하게 시험을 패스하도록 지름길이 되어드릴수 있습니다.

 

 

NO.1 To install additional switches, you must determine the ideal ISL ratio. Which ISL ratio range is
recommended for less I/O intensive application requirements (less than 70 MB/s at 2 Gb/s, less than
140 MB/s at 4 Gb/s, less than 280 MB/s at 8 Gb/s)?
A. 3:1 to 1:1
B. 1:1 to 3:1
C. 15:1 to 7:1
D. 7:1 to 15:1
Answer: D

NO.2 A single Fibre Channel router is implemented in an existing SAN. What can be accomplished?
A. fabric management service
B. fabric interconnection without merge
C. SAN availability improvement
D. SAN extension across long distances
Answer: B

NO.3 Which Fibre Channel timing variables must match in an interoperable fabric?
A. Timing variables do not need to match.
B. R_A_TOV, E_D_TOV and B_B_TOV
C. R_A_TOV and E_D_TOV
D. R_A_TOV and B_B_TOV
Answer: C

NO.4 Which information should be included in the topology map documentation of a SAN design
provided to your support organization? (Select two.)
A. serial numbers of connected servers
B. SAN switch zoning configurations
C. storage controller operating mode parameters
D. IP addresses of the connected servers
E. World Wide Names of all nodes and devices
Answer: B,E

NO.5 You are preparing for a homogeneous fabric merge and notice the customer set the same
domain ID for all fabrics. What will happen if this is not corrected?
A. Enabled zone configurations are immediately disabled.
B. Domain IDs remain unchanged and the fabrics become segmented.
C. Domain IDs are automatically renumbered and the fabrics merge, but port zoning is affected.
D. Domain IDs are automatically renumbered and the fabrics merge without any side effect.
Answer: B