Juniper JN0-530 (Juniper networks Certified internet specialist(jncis-fwv))시험을 패스하고 싶다면Pass4Test에서 출시한  Juniper JN0-530 (Juniper networks Certified internet specialist(jncis-fwv))덤프가 필수이겠죠. Juniper JN0-530 (Juniper networks Certified internet specialist(jncis-fwv))시험을 통과하여 원하는 자격증을 취득하시면 회사에서 자기만의 위치를 단단하게 하여 인정을 받을수 있습니다.이 점이 바로 많은 IT인사들이  Juniper JN0-530 (Juniper networks Certified internet specialist(j ncis-fwv))시험에 도전하는 원인이 아닐가 싶습니다.

 

 

NO.1 What is the recommended order for a basic policy-based VPN configuration?
A.1,4,3,5,2
B.2,1,4,3,5
C.2,3,5,1,4
D.3,5,1,3,2
Answer: C

NO.2 Which is a valid Phase 2 IKE proposal?
A.pre-g1-des-md5
B.rsa-g2-3des-sha
C.g2-esp-3des-md5
D.g2-esp-aes120-md5
Answer: C

NO.3 What is the maximum number of ports that can be added to an aggregate interface group on a 24 FE
card?
A.2
B.4
C.5
D.8
E.16
Answer: D

NO.4 Which two commands would be necessary to set up a default route on a NetScreen device using two
virtual routers? The default path is connected to vr-untrust, with a next-hop address of 1.1.8.1.
A.set route 0.0.0.0/0 vrouter untrust-vr
B.set vrouter trust-vr route 0.0.0.0/0 gate 1.1.8.1
C.set vrouter untrust-vr route 0.0.0.0/0 int untrust
D.set route 0.0.0.0/0 int untrust gateway 1.1.8.1
E.set vrouter untrust-vr route 0.0.0.0/0 gate 1.1.8.1
Answer: AE

NO.5 You are a read/write VSYS administrator. Your configuration requires the use of a DIP. Which statement
correctly describes this situation?
A.DIP creation can only be done by the root administrator, not a VSYS administrator
B.You can create the DIP on any interface imported into your VSYS, but not on shared interfaces
C.You can create DIPs on any interface you can see in your interface list, including both private and
shared interfaces
D.You can create DIPs only on sub-interfaces within your VSYS. All other DIPs need to be created by the
root level VSYS admin
Answer: A

NO.6 Which two (2) processes are able to use certificates on a NetScreen device?
A.IKE Phase 2 VPNS
B.Certify NTP Servers
C.IKE Phase 1 Gateways
D.Management using SNMP
E.Management SSL traffic
Answer: CE

NO.7 How can you view the value of a Phase 1 pre-shared key on a device running ScreenOS 5.0 or later?
A.get ike gateway
B.get ike pre-share
C.get conf | inc gateway
D.You cannot retrieve the pre-shared key value. It is encrypted and cannot be viewed.
Answer: D

NO.8 What are the minimum configuration requirements for configuring a NetScreen device for
administrative access? (select the best two (2) answers)
A.Policies
B.Adding routes
C.SNMP configuration
D.Interface addressing
E.Creating an administrator
Answer: BD

NO.9 When using NSRP, what command will insure uninterrupted communications for VPNs using certificates
for authentication?
A.set hostname
B.set NSRP clustername
C.set NSRP cluster name
D.set NSRP cluster hostname
Answer: C

NO.10 Place the following items in the order most closely matches the NetScreen Packet Flow process.
A.2,1,3,5,4
B.4,2,3,1,5
C.5,2,1,3,4
D.5,3,2,1,4
E.5,4,3,2,1
Answer: D

NO.11 Which component is responsible for performing both the forwarding lookup and policy evaluation on
the first packet in a session received by an NS-500?
A.RAM
B.CPU
C.ASIC on system board
D.ASIC on interface card
Answer: B

NO.12 You need to investigate some physical layer problems. Which command will provide you with
information that you can use to analyze these type of problems?
A.get log event
B.get counter screen
C.get counter flow interface
D.get counter statistics interface
Answer: D

NO.13 Click the Exhibit button.
You are having problems with traffic getting to destinations out of interface Ethernet 1. You execute a "get
route" command and get the results seen in the exhibit. What can you determine from the this routing
table?
A.The physical link may be down on the interface and that problem has to be corrected
B.Since the preference is 0 it is not being chosen to pass any routes. You must configure the preference
to be a higher value
C.Ethernet 1 does not have a gateway assigned to it so the system does not know where to send the
traffic using that interface
D.You cannot tell why traffic would not be going out Ethernet 1. You will need to try other troubleshooting
commands to find your problem
Answer: A

NO.14 Which messages exchange certificates during IKE Main Mode negotiations?
A.Messages 1 & 2
B.Messages 2 & 3
C.Messages 3 & 4
D.Messages 5 & 6
E.Certificates are not exchanged in main mode.
Answer: D

NO.15 Which two (2) route-based VPN configurations would still require a policy?
A.A policy is never needed to get traffic to a route-based VPN
B.The tunnel interface is in a different zone than the traffic source interface
C.The tunnel interface is in a different zone than the traffic destination interface
D.The tunnel interface is in the same zone as the traffic source interface and intra-zone blocking is turned
off
Answer: BC