IT인증,IT자격증,IT자격증시험,IT인증시험

http://www.pass4test.net/

Juniper JN0-532 (FWV,Specialist (JNCIS -FWV)) 시험대비덤프

Pass4Test의  Juniper JN0-532 (FWV,Specialist (JNCIS -FWV)) 시험덤프공부자료 출시 당시 저희는 이런 크나큰 인지도를 갖출수 있을지생각도 못했었습니다. 저희를 믿어주시고 구매해주신 분께 너무나도 감사한 마음에 더욱 열심히 해나가자는 결심을 하였습니다. Junip er JN0-532 (FWV,Specialist (JNCIS -FWV)) 덤프자료는 Pass4Test의 전문가들이 최선을 다하여 갈고닦은 예술품과도 같습니다.100% 시험에서 패스하도록 저희는 항상 힘쓰고 있습니다.

 

 

NO.1 Which two item pairs are exchanged during Phase 2 negotiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: AD

NO.2 You have entered the command set ffilter src-ip 1.1.7.250 dst-ip 10.1.10.5 ip-prot 6
What will be the resulting output in the debug for which this was created?
A.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has TCP as its protocol then it will be
captured
B.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has UDP as its protocol then it will be
captured
C.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has TCP as its protocol then it will
be captured
D.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has UDP as its protocol then it will
be captured
Answer: C

NO.3 Review the exhibit.
You've been asked to build a route-based hub and spoke network, with policy control for traffic travelling
from spoke to spoke. Which two of the following configuration options will meet this requirement?
(Choose two.)
A.Place the spoke tunnel interfaces in the trust zone and create policies on the spokes.
B.Place the spoke tunnel interfaces in the untrust zone and create policies on the spokes.
C.Create a single tunnel interface in the trust zone at the hub and enable intra-zone blocking.
D.Create separate tunnel interfaces at the hub and place them in different zones, then create policies at
the hub.
Answer: BD

NO.4 Which command is used to verify that IGMP is running correctly?
A.get route igmp
B.get igmp query
C.set igmp query interface e0/1
D.exec igmp interface e0/1 query
Answer: D

NO.5 What must be configured differently for a route-based VPN and a policy-based VPN?
A.proxy-id
B.proposals
C.remote gateway type
D.binding the tunnel interface
Answer: D
Posted 2013/8/30 6:49:16  |  Category: 미분류  |  Tag: