Pass4Test에서 발췌한  Cisco 642-980 (Troubleshooting Cisco Data Center Unified Fabric (DCU FT))덤프는 전문적인 IT인사들이 연구정리한 최신버전  Cisco 642-980 (Troubleshooting Cisco Data Center Unified Fabric (DCUFT))시험에 대비한 공부자료입니다.Cisco 642-980 (Troubleshooting Cisco Data Center Unified Fabric (DCUFT))덤프에 있는 문제만 이해하고 공부하신다면 Cisco 642-980 (Troubleshooting Cisco Data Center Unified Fabric (DCUFT)) 험을 한방에 패스하여 자격증을 쉽게 취득할수 있을것입니다.

 

 

 

NO.1 There is an ARP storm in VDC 1. Some users on VDC 2 notice that ARP is not resolving for their
gateways on the Cisco Nexus core. What is the cause?
A. The ARP traffic in VDC 1 is copied to the host ports in VDC 2,causing overutilization and output
discards.
B. Because the ARP process in the default VDC (VDC 1) is responsible for processing ARPtraffic
for all VDCs, VDC 2 will be affected.
C. The administrator has not correctly configured the ARP CoPP class in VDC 2.
D. The ARP CoPP class committed information rate is exceeded, resulting in ARP lossin all VDCs.
Answer: D

NO.2 Which command is used to check for potential vPC configuration consistency problems?
A. showvpc brief interface
B. show vpc global config
C. show vpc consistency-parameters global
D. showvpc config
Answer: C

NO.3 Which statement is true regarding FHRP considerations for an OTV network?
A. Filtering FHRP across the OTV network is recommended to avoid a suboptional path due to the
election of a single default gateway.
B. Using an AED eliminates the need for FHRP .
C. VRRP is recommended over HSRP or GLBP .
D. FHRP should be limited to only the internal OTV interfaces.
Answer: A

NO.4 Which command would you use to find the AED of an extended VLAN in a dual-homed site of
an
OTV network?
A. show otv aed on the AED
B. show otvvlan on any edge devices in the site
C. show otv vlan on the AED
D. show otvaed on any edge devices in the site
E. show otv site on any edge devices in the site
Answer: C

NO.5 A customer is troubleshooting FCoE in its network. They have discovered that vFC is currently
down and there is no active STP port state on the bound Ethernet interface. What should the STP
port state be to correct this issue?
A. The bound interface should be in an STP forwarding state for both the native VLANand the
member FCoE VLAN that is mapped to the active VSAN.
B. The bound interface should be in an STP blocking state for both the native VLANand the
member FCoE VLAN that is mapped to the active VSAN.
C. The bound interface should be in an STP learning state for both the native VLANand the
member FCoE VLAN that is mapped to the active VSAN.
D. The bound interface should be in an STP forwarding state for the native VLAN only.
Answer: A

NO.6 You customer is an ISP providing service to thousands of end customers. Its main concern are
focused on using up the total number of 4096 VLANs per VDC, wasting an unused block of IP
addresses, and IP address management. Which technique will address these concerns?
A. create mapping between the VLAN and VSAN to run FCoE to consolidate VLAN and IP
address
B. segment VLANs using secondary IP addresses, which will reduce the management domain
C. create a separate VDC to scale VLAN limitation and upgrade to Cisco Nexus 7018 Switch
D. use PVLANs,which will solve the scalability problem and provide IP address management
Answer: D

NO.7 A customer is deploying multihop FCoE in its network. Which guideline must the customer
follow
with respect to VE ports to make this deployment possible?
A. VE-port interface binding to MAC addresses is supported.
B. AVE port is disabled for trunk mode by default.
C. Auto mode on the vFC interface is supported.
D. VE-port trunking is supported over FCoE-enabled VLANs.
Answer: D