Pass4Test덤프공부가이드는 업계에서 높은 인지도를 자랑하고 있습니다. Pass4Test제품은 업데이트가 가장 빠르고 적중율이 가장 높아 업계의 다른 IT공부자료 사이트보다 출중합니다. Pass4Tes t 의 Cisco 200-120 (CCNA Cisco Certified Network Associate CCNA (803)) 덤프는 이해하기 쉽고 모든  Cisco 200-120 (CCNA Cisco Certified Network Associate CCNA (803)) 시험유형이 모두 포함되어 있어 덤프만 잘 이해하고 공부하시면 시험패스는 문제없습니다.

 

 

NO.1 Which of the following describes the roles of devices in a WAN? (Choose three.)
A. A CSU/DSU terminates a digital local loop.
B. A modem terminates a digital local loop.
C. A CSU/DSU terminates an analog local loop.
D. A modem terminates an analog local loop.
E. A router is commonly considered a DTE device.
F. A router is commonly considered a DCE device.
Answer: A,D,E

NO.2 A network interface port has collision detection and carrier sensing enabled on a shared
twisted
pair network. From this statement, what is known about the network interface port?
A. This is a 10 Mb/s switch port.
B. This is a 100 Mb/s switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
Answer: C

NO.3 Which layer in the OSI reference model is responsible for determining the availability of the
receiving program and checking to see if enough resources exist for that communication?
A. transport
B. network
C. presentation
D. session
E. application
Answer: E

NO.4 A receiving host computes the checksum on a frame and determines that the frame is
damaged.
The frame is then discarded. At which OSI layer did this happen?
A. session
B. transport
C. network
D. data link
E. physical
Answer: D

NO.5 A network administrator is verifying the configuration of a newly installed host by establishing
an
FTP connection to a remote server. What is the highest layer of the protocol stack that the network
administrator is using for this operation?
A. application
B. presentation
C. session
D. transport
E. internet
F. data link
Answer: A