Pass4Test는 Pass4Test의 Cisco  TelePresence Video 650-296덤프자료를 공부하면 한방에 시험패스하는것을 굳게 약속드립니다. Pass4Test의  Cisco  TelePresence Video 650-296덤프로 공부하여 시험불합격받으면 바로 덤프비용전액 환불처리해드리는 서비스를 제공해드리기에 아무런 무담없는 시험준비공부를 할수 있습니다.

 

 

NO.1 How does the VCS Expressway allow secure traversal of a firewall?
A. It uses a designated port to allow all traffic to pass through the firewall
B. It takes the place of a firewall to control trusted messages using a pre-set list of destinations
C. It makes outbound connections only
D. It prohibits all incoming and outgoing message from untrusted destinations
Answer: C

NO.2 Which three methods can be used to start a conference with the Cisco TelePresence Video
Communication Server? (Choose three)
A. Use the web interface of the Cisco TelePresence Video Communication Server
B. Use the Cisco TelePresence System user interface
C. Call directly into a conference from an endpoint
D. Use a FindMe connetion
E. Connect to a VCS Expressway from an IP endpoint
F. Receive a request-for-conference call from a connected user
G. Use the Cisco TelePresence remote control
Answer: BCG

NO.3 Which MSE blade provides high-definition multipoint control unit support?
A. Cisco MSE 8510 Media2
B. Cisco MSE 8420 Media
C. Cisco MSE 8350 IP GW
D. Cisco MSE 8220 VCR
Answer: A

NO.4 Which of these is a disadvantage of a single-zone (VCS) WAN model?
A. No endpoints will be able to place calls if connectivity is lost to the VCS location
B. Not all signaling goes through the VCS in the headquarters, causing signaling traffic across the WAN
link
C. If interworking is required, the media does not go through the VCS in the headquarters, even if the
video call is from a branch office endpoint to another endpoint in that office
D. Flexibility cannot be assured in the headquarters configuration
Answer: A

NO.5 Refer to the exhibit,
Which deployment model is represented.?
A. campus multizone
B. WAN multizone
C. campus single zone
D. WAN single zone
Answer: D

NO.6 Your network uses a combination of SIP and H.323 endpoints. When planning to implement firewalls for
security, what device permits traversal of the firewall for there devices?]
A. Gateway
B. VCS Expressway
C. Tandberg Management Suite
D. multipoint control unit
E. Cisco TelePresence
Answer: B

NO.7 Why would you include include a gateway in your design?
A. Gateways assist in video and conferencing integration
B. Gateways allow for simplification of the address plan by elimination the need for dialing a full PSTN
number
C. Gateways provide network translation if varying protocols are used
D. Gateways are required to integrate multiple endpoints
Answer: C

NO.8 Which of these is an advantage of the multizone model VCS with Prefix Dialing?
A. Location requests are only sent to the relevant zone
B. Location VCS servers only need to know about the directory VCS and do not need to know about any
other local VCS
C. When adding a new zone, only the directory gatekeeper needs to be configured
D. All gatekeepers know about all calls at times
Answer: A

NO.9 Which two of these configurations must be applied when dialing from an IP endpoint to an ISDN
destination? (Choose two)
A. A dial plan rule must be created
B. Gateway services numbers should mimic incoming PSIT routing methods
C. The Cisco TelePresence Software Version TC4.0 protocol is required
D. DID mapping must be configured on the ISDN gateway Build Your Dreams
E. A prefix must be registered with the gatekeeper
Answer: AE

NO.10 Which two of these tasks should be completed to enable calls through a firewall? (Choose two)
A. Create one traversal server zone on the VCS Expressway for any VCS Control that is running a
traversal client
B. Configure the traversal server zone with details of the corresponding zone on the traversal client
C. Create a traversal server zone on your local VCS Control Build Your Dreams
D. Configure VCS with details of the corresponding zone on the traversal server
E. Create a traversal client zone on your local VCS Control
Answer: AE