Pass4Test에는 아주 엘리트한 전문가들로 구성된 팀입니다.   Pass4Test 는 아주 정확하게 또한 아주 신속히  Juniper JN0-522 (FXV,Associate (JNCIA-FWV))  관한 자료를 제공하며, 업데이트 될 경우 또한 아주 빠르게 뉴 버전을 여러분한테 보내드립니다. Pass4Test는 관련 업계에서도 우리만의 브랜드 이미지를 지니고 있으며 많은 고객들의 찬사를 받았습니다. Pass4Test 의  Juniper JN0-522 (FXV,Associate (JNCIA-FWV))  자료로 자신만만한 시험 준비 하시기를 바랍니다. 우리를 선택함으로 자신의 시간을 아끼는 셈이라고 생각하시면 됩니다.   Juniper JN0-522 (FXV,Associate (JNCIA-FWV))  로 빠른 시일내에 자격증 취득하시고  Juniper JN0-522 (FXV,Associate (JNCIA-FWV))    IT업계중에 엘리트한 전문가로 되시기를 바랍니다.

 

NO.1 Click the Exhibit button. In the exhibit, which two forms of address translation would have generated
the output shown? (Choose two.)
A.MIP
B.NAT-src with no DIP
C.Interface-based translation
D.NAT-src with a DIP, fixed-port disabled
Answer:B C

NO.2 What is the purpose of the VLAN1 interface?
A.It provides policy-based NAT for 802.1Q VLANs.
B.It provides an interface that can be used with 802.1Q VLANs in transparent mode.
C.It provides the ScreenOS device with a routable IP address while operating in route mode.
D.It provides an interface that can be used to remotely manage the ScreenOS device while operating in
transparent mode.
Answer:D

NO.3 Which ScreenOS CLI command would be used to view traffic logs?
A.get traffic
B.get log policy
C.get policy log
D.get log traffic
Answer:D

NO.4 Which command can you use to view the log of IKE negotiations and results?
A.get event type 536
B.get ike cookie
C.get sa active
D.debug ike basic
Answer:A

NO.5 Click the Exhibit button. In the exhibit, what is the correct command to configure a default route on the
SSG 20?
A.set route 0.0.0.0/0 vrouter untrust
B.set route 0.0.0.0/0 interface e0/4 gateway 143.45.56.254
C.set route 0.0.0.0/0 interface e0/4 next-hop 143.45.56.254
D.set route 0.0.0.0/0 interface 143.45.56.1 gate 143.45.56.254
Answer:B

NO.6 What is the purpose of the "Permitted IP" address on a ScreenOS device?
A.It defines a list of addresses that are trusted to perform management on the ScreenOS device.
B.It is used in policy rules to determine which user traffic is allowed through the ScreenOS device.
C.It defines which range of addresses that can access devices connected to the ScreenOS device.
D.It is the address that an external device uses to gain management access to a ScreenOS device.
Answer:A

NO.7 What are two benefits of configuring a ScreenOS device in transparent mode? (Choose two.)
A.There is no need to reconfigure the IP addresses of routers or protected servers.
B.There is no need to create MIPs or VIPs for incoming traffic to reach protected servers.
C.Policies are easier to create since you do not have to include source and destination IP addresses.
D.The product can support more VPNs and obtain greater throughput because there is less overhead to
manage.
Answer:A B

NO.8 You want to minimize the number of IP addresses, subnets, and policies in use. How should you
configure your tunnel interface?
A.Configure the tunnel interface with an IP address with a 32 bit subnet mask.
B.Configure the tunnel interface with an IP address with a 30 bit subnet mask.
C.Configure the tunnel interface as unnumbered and place the interface in the same zone as the
designated interface.
D.Configure the tunnel interface as unnumbered, but place the tunnel interface in a different zone than the
designated interface.
Answer:C

NO.9 Click the Exhibit button. In the exhibit, what is the correct address book entry for host C?
A.set address C 1.1.70.250/32
B.set address Partner C 1.1.70.250
C.set address Partner 1.1.70.250/32
D.set address Partner C 1.1.70.250/32
Answer:D

NO.10 Click the Exhibit button. In the exhibit, which routing command would allow host A to communicate with
host C? (Note: Assume a route from the SSG 20 to host A's subnet already exists.)
A.set route 0.0.0.0/0 int e0/3 gateway 177.11.56.254
B.set route 1.1.70.0 interface e0/3 gateway 177.11.56.254
C.configure route 1.1.70.0/24 gateway 177.11.56.254 int e0/3
D.set route 1.1.70.0/24 interface e0/3 gateway 177.11.56.254
Answer:D

NO.11 You enter the following command: set int e0/8 mip 1.1.8.32 host 10.1.10.32 netmask 255.255.255.255
How many MIP address translations have you just configured?
A.1
B.8
C.128
D.256
Answer:A

NO.12 Click the Exhibit button. In the exhibit, if host A initiates a Web browsing session with host D, and the
E0/1 interface of the SSG 20 is in NAT mode, what will be the source address of the packet arriving at
host D?
A.10.1.1.1
B.10.1.10.5
C.143.45.56.1
D.143.45.56.254
Answer:C

NO.13 Which ScreenOS CLI command is required to enable a policy during specified times, days, or dates?
A.set time
B.set clock
C.set calendar
D.set scheduler
Answer:D

NO.14 Click the Exhibit button. Traffic from the Internet to the partner servers must use a VIP. In the exhibit,
what is true about the configuration of this feature?
A.You cannot use a VIP in this environment.
B.The VIP can be configured on the e0/4 interface.
C.The VIP can be configured in the Corporate or Internet zone using a different subnet than the physical
interface.
D.The VIP will work only if the destination ports in the incoming packet headers are mapped to the same
ports in the Corporate zone.
Answer:A

NO.15 Which ScreenOS CLI command would be useful for troubleshooting a policy deny?
A.get flow debug
B.debug flow basic
C.exec flow analysis
D.debug session basic
Answer:B

 

IT인증자격증만 소지한다면 일상생활에서 많은 도움이 될것입니다. 하지만 문제는 어떻게  간단하게 시험을 패스할것인가 입니다. Pass4Test는 IT전문가들이 제공한 시험관련 최신 연구자료들을 제공해드립니다.Pass4Test을 선택함으로써 여러분은 성공도 선택한것이라고 볼수 있습니다.