인터넷에는  CCNP 642-637시험대비공부자료가 헤아릴수 없을 정도로 많습니다.이렇게 많은  CCNP 642-637공부자료중 대부분 분들께서 저희 Pass4Test를 선택하는 이유는 덤프 업데이트가 다른 사이트보다 빠르다는 것이 제일 큰 이유가 아닐가 싶습니다. Pass4Test의 CCNP 642-637덤프를 구매하시면 덤프가 업데이트되면 무료로 업데이트된 버전을 제공받을수 있습니다.

 

 

NO.1 Refer to the exhibit.
Given the partial output of the debug command, what can be determined?
A. There is no ID payload in the packet, as indicated by the message ID = 0.
B. The peer has not matched any offered profiles.
C. This is an IKE quick mode negotiation.
D. This is normal output of a successful Phase 1 IKE exchange.
Answer: B

NO.2 Refer to the exhibit.
What can be determined about the IPS category configuration shown?
A. All categories are disabled.
B. All categories are retired.
C. After all other categories were disabled, a custom category named "os ios" was created
D. Only attacks on the Cisco IOS system result in preventative actions.
Answer: D

NO.3 You are running Cisco IOS IPS software on your edge router. A new threat has become an issue. The
Cisco IOS IPS software has a signature that can address the new threat, but you previously retired the
signature. You decide to unretire that signature to regain the desired protection level. How should you act
on your decision?
A. Retired signatures are not present in the routers memory. You will need to download a new signature
package to regain the retired signature.
B. You should re-enable the signature and start inspecting traffic for signs of the new threat.
C. Unretiring a signature will cause the router to recompile the signature database, which can temporarily
affect performance.
D. You cannot unretire a signature. To avoid a disruption in traffic flow, it's best to create a custom
signature until you can download a new signature package and reload the router.
Answer: C

NO.4 Refer to the exhibit.
What can be determined from the output of this show command?
A. The IPsec connection is in an idle state.
B. The IKE association is in the process of being set up.
C. The IKE status is authenticated.
D. The ISAKMP state is waiting for quick mode status to authenticate before IPsec parameters are
passed between peers
E. IKE Quick Mode is in the idle state, indicating a problem with IKE phase 1.
Answer: C

NO.5 DRAG DROP
Answer:

NO.6 Which statement best describes inside policy based NAT?
A. Policy NAT rules are those that determine which addresses need to be translated per the enterprise
security policy
B. Policy NAT consists of policy rules based on outside sources attempting to communicate with inside
endpoints.
C. These rules use source addresses as the decision for translation policies.
D. These rules are sensitive to all communicating endpoints.
Answer: A

NO.7 When configuring a zone-based policy firewall, what will be the resulting action if you do not specify any
zone pairs for a possible pair of zones?
A. All sessions will pass through the zone without being inspected.
B. All sessions will be denied between these two zones by default.
C. All sessions will have to pass through the router "self zone" for inspection before being allowed to pass
to the destination zone.
D. This configuration statelessly allows packets to be delivered to the destination zone.
Answer: B

NO.8 Refer to the exhibit.
Which two Cisco IOS WebVPN features are enabled with the partial configuration shown? (Choose two.)
A. The end-user Cisco AnyConnect VPN software will remain installed on the end system.
B. If the Cisco AnyConnect VPN software fails to install on the end-user PC, the end user cannot use
other modes.
C. Client based full tunnel access has been enabled.
D. Traffic destined to the 10.0.0.0/8 network will not be tunneled and will be allowed access via a split
tunnel.
E. Clients will be assigned IP addresses in the 10.10.0.0/16 range.
Answer: A,C

NO.9 Which Cisco IOS IPS feature allows to you remove one or more actions from all active signatures
based on the attacker and/or target address criteria, as well as the event risk rating criteria?
A. signature event action filters
B. signature event action overrides
C. signature attack severity rating
D. signature event risk rating
Answer: A

NO.10 When Cisco IOS IPS is configured to use SDEE for event notification, how are events managed?
A. They are stored in the router's event store and will allow authenticated remote systems to pull events
from the event store.
B. All events are immediately sent to the remote SDEE server.
C. Events are sent via syslog over a secure SSUTLS communications channel.
D. When the event store reaches its maximum configured number of event notifications, the stored events
are sent via SDEE to a remote authenticated server and a new event store is created.
Answer: A

NO.11 DRAG DROP
Answer:

NO.12 You are troubleshooting reported connectivity issues from remote users who are accessing corporate
headquarters via an IPsec VPN connection. What should be your first step in troubleshooting these
issues?
A. issue a show crypto isakmp policy command to verify matching policies of the tunnel endpoints
B. ping the tunnel endpoint
C. run a traceroute to verify the tunnel path
D. debug the connection process and look for any error messages in tunnel establishment
Answer: B

NO.13 Which of these is a configurable Cisco IOS feature that triggers notifications if an attack attempts to
exhaust critical router resources and if preventative controls have been bypassed or are not working
correctly?
A. Control Plane Protection
B. Management Plane Protection
C. CPU and memory thresholding
D. SNMPv3
Answer: C

NO.14 Which of these allows you to add event actions globally based on the risk rating of each event, without
having to configure each signature individually?
A. event action summarization
B. event action filter
C. event action override
D. signature event action processor
Answer: C

NO.15 Which two of these will match a regular expression with the following configuration parameters?
[a-zA-Z][0-9][a-z] (Choose two.)
A. Q3h
B. B4Mn
C. aaB132AA
D. c7lm
E. BBpjnrIT
Answer: A,D

NO.16 Which of these is correct regarding the configuration of virtual-access interfaces?
A. They cannot be saved to the startup configuration.
B. You must use static routes inside the tunnels.
C. DVTI interfaces should be assigned a unique IP address range.
D. The Virtual-Access 1 interface must be enabled in an up/up state administratively
Answer: A

NO.17 Which two of these are benefits of implementing a zone-based policy firewall in transparent mode?
(Choose two.)
A. Less firewall management is needed.
B. It can be easily introduced into an existing network.
C. IP readdressing is unnecessary.
D. It adds the ability to statefully inspect non-IP traffic.
E. It has less impact on data flows.
Answer: B,C

NO.18 Refer to the exhibit.
The INSIDE zone has been configured and assigned to two separate router interfaces. All other zones
and interfaces have been properly configured. Given the configuration example shown, what can be
determined?
A. Hosts in the INSIDE zone, with addresses in the 10.10.10.0/24 network, can access any host in the
10.10.10.0/24 network using the SSH protocol.
B. If a host in the INSIDE zone attempts to communicate via SSH with another host on a different
interface within the INSIDE zone, communications must pass through the router self zone using the
INTRAZONE policy.
C. This is an illegal configuration. You cannot have the same source and destination zones.
D. This policy configuration is not needed, traffic within the same zone is allowed to pass by default.
Answer: D

NO.19 Which action does the command private-vlan association 100,200 take?
A. configures VLANs 100 and 200 and associates them as a community
B. associates VLANs 100 and 200 with the primary VLAN
C. creates two private VLANs with the designation of VLAN 100 and VLAN 200
D. assigns VLANs 100 and 200 as an association of private VLANs
Answer: B

NO.20 When using Cisco Easy VPN, what are the three options for entering an XAUTH username and
password for establishing a VPN connection from the Cisco Easy VPN remote router? (Choose three.)
A. using an external AAA server B. entering the information via the router crypto ipsec client ezvpn
connect CLI command in privileged EXEC mode
C. using the router local user database
D. entering the information from the PC via a browser
E. storing the XAUTH credentials in the router configuration file
Answer: B,D,E