Pass4Test는 Pass4Test의  Cisco 648-247 (Implementing Cisco Connected Physical Security 2 Exam) 덤프자료를 공부하면 한방에 시험패스하는것을 굳게 약속드립니다. Pass4Test의  Cisco 648-247 (Implementing Cisco Connected Physical Security 2 Exam) 덤프로 공부하여 시험불합격받으면 바로 덤프비용전액 환불처리해드리는 서비스를 제공해드리기에 아무런 무담없는 시험준비공부를 할수 있습니다.

 

 

NO.1 Cisco Physical Access Manager (Cisco PAM) is an appliance-based solution. The Cisco PAM 1.3.2
appliance is available on which of the following server platforms?
A. CIVS-MSP-1RU-K9
B. CPS-MSP-1RU-K9
C. CPS-MSP-2RU-K9
D. CIAC-PAME-1125-K9
Answer: B

NO.2 Refer to the exhibit.
One or more expansion modules is connected to the Cisco Access Gateway via a CAN bus. How should
the CAN bus wires be connected after the last module in the chain?
A. The CAN bus wires should be looped back to the Cisco Access Gateway.
B. The CAN bus wires should be twisted together and tucked away.
C. The CAN bus wires should be plugged into a Layer 2 Ethernet switch.
D. The CAN bus wires should be terminated with a high-impedance resistor.
Answer: D

NO.3 When a 24 VDC fail safe lock is being used to secure a door, how should power be supplied to the lock
from the control source?
A. connected +24 VDC directly to the lock
B. connected +24 VDC through common and normally close
C. connected +24 VDC through common and normally open
D. connected +5 VDC binary control signaling
Answer: B

NO.4 What are the four main components of a typical logical door?
A. door, door knob, door jam, and hinges
B. lock, reader, tailgate sensor, and motion detector
C. lock, request to exit, door position switch, and swing arm
D. lock, reader, request to exit, and door position switch
Answer: D

NO.5 What are the three common methods that are used for authentication with an access control system.?
A. badge card, key fob, and keypad PIN
B. badge card, keypad PIN, and password
C. something you know, something you have, and something you are
D. something you know, something you have, and something you did
Answer: C