NO.1 In a single-site deployment model, the internal endpoints are unable to
dial from one to the
other. What are two possible causes? (Choose two.)
A.
The calling endpoint is not in the CSS of the called endpoint.
B. The called
endpoint is not in the partition of the calling endpoint.
C. The called
endpoint does not have the SIP trunk enabled.
D. The calling endpoint is not
configured for the correct CoS.
E. The PSTN gateway is not configured.
F.
The called endpoint is not registered.
Answer: D,F
300-080덤프자료 300-080자격증시험
NO.2
You have 50 hardware MTP resources and 200 software MTP resources.
You want
to use hardware resources first, but software is being used first.
Where can
you confirm the MTP selection order?
A. Media Resource Group List
B. MGCP
gateway
C. calling search space
D. phone device pool
E. Cisco Unified
Real-Time Monitoring Tool
F. MTP list
Answer:
A
300-080인증덤프
NO.3 To achieve 720p (HD)
quality at 30 frames per second on an endpoint that is running TC
software,
what is the minimum configured call rate?
A. 512 kbps
B. 2560 kbps
C.
768 kbps
D. 1152 kbps
Answer: D
300-080 IT덤프
NO.4
When dialing any external SIP URI for a business-to-business call, an endpoint
that is registered
to the Cisco VCS Control fails to locate the remote
endpoint. The same endpoint can successfully call
another endpoint that is
registered to the Cisco VCS Expressway. How do you resolve this issue?
A.
Configure a proper DNS zone on the Cisco VCS Expressway.
B. Configure a SIP
route pattern in Cisco Unified Communications Manager.
C. Add a multisite
option to the endpoint.
D. Add traversal call licensing on the Cisco VCS
Expressway.
E. Configure a traversal zone between the Cisco VCS Control and
the Cisco VCS Expressway.
F. Add traversal call licensing on the Cisco VCS
Control.
Answer: A
300-080자격시험
NO.5 Refer
to the exhibit.
These settings are configured on a Cisco TelePresence System
EX90. What is the result?
A. The endpoint does not register to Cisco VCS as a
SIP endpoint, because the domain information is
missing.
B. The endpoint
successfully registers to Cisco Unified Communications Manager as a SIP
endpoint.
C. The endpoint does not register to Cisco Unified Communications
Manager as a SIP endpoint,
because the domain information is missing.
D.
The endpoint successfully registers to Cisco VCS as an H.323 endpoint.
E. The
endpoint successfully registers to Cisco VCS as a SIP endpoint.
F. The
endpoint successfully registers to Cisco Unified Communications Manager as an
H.323
endpoint.
Answer:
D
300-080시험문제
NO.6 You install a second Cisco
TelePresence PrecisionHD 1080p camera on your C-Series Codec, but
you are
unable to control the camera. What should you do to fix this issue?
A. Order
a VISCA cascading cable from Cisco, which connects the first camera to the
second camera.
B. Ensure that the distance between the end user and the
camera is between 4 feet and 6 feet.
C. Ensure that the HD-SDI cable between
the codec and the camera is not longer than 100 meters
(330 feet).
D.
Purchase and install a camera with full pan, tilt, and zoom capabilities.
E.
Ensure that the RJ45 end of the camera cable goes to the connector that is
marked "HD Video Out
Codec."
Answer:
A
300-080시험문제
NO.7 Which two statements
indicate something that can cause an IP phone to fail roaming when
device
mobility has been configured? (Choose two.)
A. No device mobility-related
information settings were configured under the device pools.
B. No physical
locations have been configured and assigned to the device pools.
C. No
locations have been configured and assigned to the device pools.
D. No device
mobility groups have been configured.
E. Device Mobility Mode is set to Off
in the Cisco Unified Communications Manager service
parameters while the
device mobility configuration on the phone is set to default.
Answer:
B,E
300-080 pdf
NO.8 Which four performance
counters are available when monitoring a Cisco MTP device using the
Cisco
Unified Communications Manager RTMT? (Choose four.)
A. MTP Instances
Active
B. MTP Streams Active
C. Resource Available
D. Out of
Resources
E. MTP Connection Lost
F. Resource Active
G. Resource
Total
H. Resource Idle
Answer:
C,D,F,G
300-080덤프 300-080교재
여러분은 우리. Pass4Test의Cisco 640-875기출문제 즉 덤프의 문제와 답만 있으시면Cisco 640-875기출문제을 아주 간단하게 패스하실 수 있습니다.그리고 관련 업계에서 여러분의 지위상승은 자연적 이로 이루어집니다. Pass4Test의 덤프를 장바구니에 넣으세요. 그리고 Pass4Test에서는 무료로 24시간 온라인상담이 있습니다.
시험 번호/코드: 640-875시험 이름: Building Cisco Service Provider Next-Generation Networks, Part 1 (SPNGN1)
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 640-875기출문제
PDF 및 소프트웨어, 연구와 실천
시험 번호/코드: 642-998시험 이름: Designing Cisco Data Center Unified Computing
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 642-998 dumps
PDF 및 소프트웨어, 연구와 실천
시험 번호/코드: 300-080시험 이름: Troubleshooting Cisco IP Telephony & Video v1.0
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 300-080교육
PDF 및 소프트웨어, 연구와 실천
642-998 dumps은Cisco인증시험중의 하나입니다.그리고 또한 비중이 아주 큰 인증시험입니다. 그리고Cisco 642-998 dumps 패스는 진짜 어렵다고 합니다. 우리Pass4Test에서는 여러분이642-998 dumps을 편리하게 응시하도록 전문적이 연구팀에서 만들어낸 최고의642-998 dumps를 제공합니다, Pass4Test와 만남으로 여러분은 아주 간편하게 어려운 시험을 패스하실 수 있습니다,
이 글을 보시게 된다면Cisco인증 300-080교육패스를 꿈꾸고 있는 분이라고 믿습니다. Cisco인증 300-080교육공부를 아직 시작하지 않으셨다면 망설이지 마시고Pass4Test의Cisco인증 300-080교육를 마련하여 공부를 시작해 보세요. 이렇게 착한 가격에 이정도 품질의 덤프자료는 찾기 힘들것입니다. Pass4Test의Cisco인증 300-080교육는 고객님께서 Cisco인증 300-080교육을 패스하는 필수품입니다.
Pass4Test의 경험이 풍부한 IT전문가들이 연구제작해낸 Cisco인증 300-080교육는 시험패스율이 100%에 가까워 시험의 첫번째 도전에서 한방에 시험패스하도록 도와드립니다. Cisco인증 300-080교육는Cisco인증 300-080교육최신 실제시험문제의 모든 시험문제를 커버하고 있어 덤프에 있는 내용만 공부하시면 아무런 걱정없이 시험에 도전할수 있습니다.
300-080 덤프무료샘플다운로드하기: http://www.pass4test.net/300-080.html