NO.1 CORRECT TEXT
Route.com is a small IT corporation that is attempting
to implement the network shown in the
exhibit. Currently the implementation
is partially completed. OSPF has been configured on routers
Chicago and
NewYork. The SO/O interface on Chicago and the SO/1 interface on NewYork are in
Area
0. The loopbackO interface on NewYork is in Area 1. However, they cannot
ping from the serial
interface of the Seattle router to the loopback
interface of the NewYork router. You have been asked
to complete the
implementation to allow this ping.
ROUTE.com's corporate implementation
guidelines require:
The OSPF process ID for all routers must be 10.
The
routing protocol for each interface must be enabled under the routing
process.
The routing protocol must be enabled for each interface using the
most specific wildcard mask
possible.
The serial link between Seattle and
Chicago must be in OSPF area 21.
OSPF area 21 must not receive any inter-area
or external routes.
Network Information Seattle
S0/0 192.168.16.5/30 -
Link between Seattle and Chicago Secret Password: cisco
Chicago
S0/0
192.168.54.9/30 - Link between Chicago and NewYork S0/1 192.168.16.6/30 - Link
betwee
n Seattle and Chicago Secre Password: cisco
NewYork
S0/1
192.168.54.10/30 - Link between Chicago and NewYork Loopback0 172.16.189.189
Secret
Password: cisco
Answer:
Here is the solution
below:
Explanation:
Note: In actual exam, the IP addressing, OSPF areas
and process ID, and router hostnames may
change, but the overall solution is
the same.
Seattle's S0/0 IP Address is 192.168.16.5/30. So, we need to find
the network address and wildcard
mask of 192.168.16.5/30 in order to
configure the OSPF.
IP Address: 192.168.16.5 /30
Subnet Mask:
255.255.255.252
Here subtract 252 from 2565, 256-252 = 4, hence the subnets
will increment by 4.
First, find the 4th octet of the Network Address:
The
4th octet of IP address (192.168.16.5) belongs to subnet 1 (4 to 7).
Network
Address: 192.168.16.4
Broadcast Address: 192.168.16.7
Lets find the
wildcard mask of /30.
Subnet Mask: (Network Bits - 1's, Host Bits -
0's)
Lets find the wildcard mask of /30:
Now we configure OSPF using
process ID 10 (note the process ID may change to something else in
real
exam).
Seattle>enable
Password:
Seattle#conf
t
Seattle(config)#router ospf 10
Seattle(config-router)#network
192.168.16.4 0.0.0.3 area 21
One of the tasks states that area 21 should not
receive any external or inter-area routes (except
the default
route).
Seattle(config-router)#area 21
stub
Seattle(config-router)#end
Seattle#copy run start
Chicago
Configuration:
Chicago>enable
Password: cisco
Chicago#conf
t
Chicago(config)#router ospf 10
We need to add Chicago's S0/1 interface
to Area 21
Chicago(config-router)#network 192.168.16.4 0.0.0.3 area
21
Again, area 21 should not receive any external or inter-area routes
(except the default route).
In order to accomplish this, we must stop LSA
Type 5 if we don't want to send external routes. And
if we don't want to send
inter-area routes, we have to stop LSA Type 3 and Type 4. Therefore we
want
to configure area 21 as a totally stubby area.
Chicago(config-router)#area 21
stub no-summary
Chicago(config-router)#end
Chicago#copy run start
The
other interface on the Chicago router is already configured correctly in this
scenario, as well
as the New York router so there is nothing that needs to be
done on that router.
NO.2 Scenario:
You have been asked to evaluate an
OSPF network setup in a test lab and to answer questions a
customer has about
its operation. The customer has disabled your access to the show
running-config
command.
Which of the following statements is true about
the serial links that terminate in R3
A. The R1-R3 link needs the neighbor
command for the adjacency to stay up
B. The R1-R3 link OSPF timer values
should be 10,40,40
C. The R2-R3 link OSPF timer values are 30, 120, 120
D.
R3 is responsible for flooding LSUs to all the routers on the
network.
Answer: C
300-101자격증자료
NO.3 Refer
to the exhibit.
Which option represents the minimal configuration that allows
inbound traffic from the
172.16.1.0/24 network to successfully enter router
R, while also limiting spoofed 10.0.0.0/8 hosts
that could enter router
R?
A. (config)#interface fa0/0 (config-if)#ip verify unicast source
reachable-via any
B. (config)#ip cef (config)#interface fa0/0 (config-if)#ip
verify unicast source reachable-via rx allow-
default
C. (config)#no ip
cef (config)#interface fa0/0 (config-if)#ip verify unicast source reachable-via
rx
D. (config)#ip cef (config)#interface fa0/0 (config-if)#ip verify unicast
source reachable-via rx
Answer: B
300-101 pdf
NO.4 You
have been asked to evaluate how EIGRP is functioning in a customer
network.
What is the advertised distance for the 192.168.46.0 network on
R1?
A. 307456
B. 1938688
C. 333056
D. 1810944
Answer:
D
300-101덤프 300-101
IT자격증
NO.5 Which two authentication protocols does PPP
support? (Choose two.)
A. CHAP
B. PAP
C. EAP
D. RADIUS
E.
WAP
Answer: A,B
300-101최신덤프
NO.6 How does
an IOS router process a packet that should be switched by Cisco Express
Forwarding
without an FIB entry?
A. by dropping the packet
B. by
forwarding the packet
C. by creating a new FIB entry for the packet
D. by
looking in the routing table for an alternate FIB entry
Answer: A
NO.7
Which protocol uses dynamic address mapping to request the next-hop protocol
address for a
specific connection?
A. static DLCI mapping
B. Frame
Relay inverse ARP
C. dynamic DLCI mapping
D. Frame Relay broadcast
queue
Answer: B
300-101시험문제
NO.8 An
engineer is configuring a GRE tunnel interface in the default mode.
The
engineer has assigned an IPv4 address on the tunnel and sourced the tunnel from
an Ethernet
interface.
Which option also is required on the tunnel
interface before it is operational?
A. IPv6 address
B. tunnel
protection
C. tunnel destination address
D. keepalives
Answer:
C
300-101 Dumps 300-101 pdf
Pass4Test는IT업계전문가들이 그들의 노하우와 몇 년간의 경험 등으로 자료의 정확도를 높여 응시자들의 요구를 만족시켜 드립니다. 우리는 꼭 한번에Cisco 300-101덤프다운을 패스할 수 있도록 도와드릴 것입니다. 여러분은Cisco 300-101덤프다운 구매로 제일 정확하고 또 최신시험버전의 문제와 답을 사용할 수 있습니다. Pass4Tes의 인증시험적중 율은 아주 높습니다. 때문에 많은 IT인증시험준비중인분들에세 많은 편리를 드릴수 있습니다.100%정확도 100%신뢰.여러분은 마음편히 응시하시면 됩니다.
시험 번호/코드: 300-101시험 이름: Implementing Cisco IP Routing (ROUTE v2.0)
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 300-101덤프다운
PDF 및 소프트웨어, 연구와 실천
시험 번호/코드: 350-018시험 이름: CCIE Security Written Exam v4.0
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 350-018시험자료
PDF 및 소프트웨어, 연구와 실천
자신을 부단히 업그레이드하려면 많은 노력이 필요합니다. IT업종 종사자라면 국제승인 IT인증자격증을 취득하는것이 자신을 업그레이드하는것과 같습니다. Cisco인증 350-018시험자료을 패스하여 원하는 자격증을 취득하려면Pass4Test의Cisco인증 350-018시험자료를 추천해드립니다. 하루빨리 덤프를 공부하여 자격증 부자가 되세요.
Cisco인증350-018시험자료의 문제와 답은 모두 우리의 엘리트들이 자신의 지식과 몇 년간의 경험으로 완벽하게 만들어낸 최고의 문제집입니다. 전문적으로Cisco인증350-018시험자료을 응시하는 분들을 위하여 만들었습니다. 여러분이 다른 사이트에서도Cisco인증350-018시험자료 관련덤프자료를 보셨을 것입니다 하지만 우리Pass4Test의 자료만의 최고의 전문가들이 만들어낸 제일 전면적이고 또 최신 업데이트일 것입니다.Cisco인증350-018시험자료을 응시하고 싶으시다면 Pass4Test자료만의 최고의 선택입니다.
300-101 덤프무료샘플다운로드하기: http://www.pass4test.net/300-101.html