Cisco Specialist 200-401시험은 빨리 패스해야 되는데 어디서부터 어떻게 시험준비를 시작해야 하는지 갈피를 잡을수 없는 분들은 Pass4Test가 도와드립니다. Pass4Test의 Cisco Specialist 200-401덤프만 공부하면 시험패스에 자신이 생겨 불안한 상태에서 벗어날수 있습니다.덤프는 시장에서 가장 최신버전이기에 최신 시험문제의 모든 시험범위와 시험유형을 커버하여 Cisco Specialist 200-401시험을 쉽게 패스하여 자격증을 취득하여 찬란한 미래에 더 가깝도록 도와드립니다.
NO.1 What is the purpose of a time domain reflectometer?
A. It uses pulses to locate and test for sheath faults, damaged conductors, loose connectors, splices,
bridge taps, split pairs, and other problems.
B. It opens shorts and pinholes in cable shielding.
C. It correlates the returned light pulses with a location in the fiber.
D. It opens kinks and mismatched cable connectors.
Answer: A
NO.2 Which of the following correctly pairs the dotted decimal subnet mask with the correct number
of binary bits that represent the subnet mask?
A. 255.255.255.192 and /25
B. 255.255.255.248 and /28
C. 255.255.255.224 and /26
D. 255.255.255.248 and /27
E. 255.255.255.240 and /28
F. 255.255.255.240 and /16
Answer: E
NO.3 You are troubleshooting a connectivity problem and want to isolate the problem. You suspect
that a router on the route to an unreachable network is at fault. Which command would you issue to
see where the packets stop?
A. router#ping
B. router#tracert
C. router#show ip route
D. router#show cdp neighbors
E. router#traceroute
Answer: E
NO.4 Exhibit:
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All
the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs
have been configured with the appropriate default gateway. What is true about this configuration?
A. These commands need to be added to the configuration:C-router(config)# router eigrp 123C-
router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:C-router(config)# router ospf 1C-
router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:C-router(config)# router
ripCrouter(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
NO.5 An Ethernet cable is attached to a PC NIC and then attached to a switch port. The PC power is
turned on and the switch port link LED turns green. The link light indicates what two conditions?
(Choose two.)
A. Layer 2 communication has been established between the PC and switch.
B. The PC has received a DHCP address.
C. Traffic is being sent from the switch to the PC.
D. If flashing, the green LED indicates port speed of 100 Mb/s.
E. The Layer 1 media is functioning between the PC and switch.
F. The switch port is functioning as a half-duplex connection.
Answer: A,E