Pass4Test에서는 Aruba Certification ACMP-6.3시험대비덤프를 발췌하여 제공해드립니다. Aruba Certification ACMP-6.3시험대비덤프에는 시험문제의 모든 예상문제와 시험유형이 포함되어있어 시험준비자료로서 가장 좋은 선택입니다. Pass4Test에서 제공해드리는 전면적인 Aruba Certification ACMP-6.3시험대비덤프로 Aruba Certification ACMP-6.3시험준비공부를 해보세요. 통과율이 100%입니다.
NO.1 An Aruba Controller is configured with VLAN 1,5, 200, and 4095. All VLANs
have IP addresses
assigned. Which is the default management VLAN on the Aruba
controller?
A. VLAN 5
B. VLAN 1
C. VLAN 200
D. None, it must be
defined
E. VLAN 4095
Answer: B
NO.2 How many Aruba controllers can
be added to a single mobility domain?
A. 64 controllers of any type
B. 128
controllers supporting 2000 users
C. 256 controllers with no more than 1024
subnets
D. Controllers supporting up to 6000 AP's
E. There is no
controller limit
Answer: E
NO.3 Which command, when executed on a
master controller, will show the APs connected to all
controllers?
A. show
stm connectivity
B. show ap active
C. show ap database
D. show ap
bss-table
E. show ap controller-lms
Answer: C
NO.4 Which command
will show all client association history?
A. Aruba-6000# show mobile trail
current (ip address)
B. Aruba-6000# show ip mobile trail (ip address)
C.
Aruba-6000# show ap client status (mac address)
D. Aruba-6000# show current
client ip (ip address)
E. Aruba-6000# show client ip (ip address)
mobility
Answer: B
NO.5 An AP was configured and assigned to an AP
group then powered off for over a week. When
the AP is redeployed, what
previous configuration will it retain?
A. It's AP name and AP Group
B.
It's Serial Number
C. The controller's IP address
D. After a few days all
configurations are lost
E. The controller IP address and the AP
Group
Answer: A
NO.6 What can an AM do that an AP cannot do?
A.
Detect rogue APs
B. Detect an AP failure
C. Scans all channels in under 1
minute
D. Detect interfering APs
E. Scan all valid channels
Answer:
C
NO.7 When configuring ports in the Controller wizard, which of the
following are NOT configuration
options? (Choose two)
A. Inter-VLAN
routing
B. Speed
C. Trusted
D. LACP
E. Trunk
Answer:
A,D
NO.8 If a Remote AP (RAP) is attempting to contact a controller that
is behind a NAT device what
protocol must be allowed through the
NAT/Firewall?
A. PAPI
B. NATT
C. IPSec
D. SSH
E. GRE
Answer:
B
have IP addresses
assigned. Which is the default management VLAN on the Aruba
controller?
A. VLAN 5
B. VLAN 1
C. VLAN 200
D. None, it must be
defined
E. VLAN 4095
Answer: B
NO.2 How many Aruba controllers can
be added to a single mobility domain?
A. 64 controllers of any type
B. 128
controllers supporting 2000 users
C. 256 controllers with no more than 1024
subnets
D. Controllers supporting up to 6000 AP's
E. There is no
controller limit
Answer: E
NO.3 Which command, when executed on a
master controller, will show the APs connected to all
controllers?
A. show
stm connectivity
B. show ap active
C. show ap database
D. show ap
bss-table
E. show ap controller-lms
Answer: C
NO.4 Which command
will show all client association history?
A. Aruba-6000# show mobile trail
current (ip address)
B. Aruba-6000# show ip mobile trail (ip address)
C.
Aruba-6000# show ap client status (mac address)
D. Aruba-6000# show current
client ip (ip address)
E. Aruba-6000# show client ip (ip address)
mobility
Answer: B
NO.5 An AP was configured and assigned to an AP
group then powered off for over a week. When
the AP is redeployed, what
previous configuration will it retain?
A. It's AP name and AP Group
B.
It's Serial Number
C. The controller's IP address
D. After a few days all
configurations are lost
E. The controller IP address and the AP
Group
Answer: A
NO.6 What can an AM do that an AP cannot do?
A.
Detect rogue APs
B. Detect an AP failure
C. Scans all channels in under 1
minute
D. Detect interfering APs
E. Scan all valid channels
Answer:
C
NO.7 When configuring ports in the Controller wizard, which of the
following are NOT configuration
options? (Choose two)
A. Inter-VLAN
routing
B. Speed
C. Trusted
D. LACP
E. Trunk
Answer:
A,D
NO.8 If a Remote AP (RAP) is attempting to contact a controller that
is behind a NAT device what
protocol must be allowed through the
NAT/Firewall?
A. PAPI
B. NATT
C. IPSec
D. SSH
E. GRE
Answer:
B