IT인증,IT자격증,IT자격증시험,IT인증시험

http://www.pass4test.net/

VMware Certification VCI550인증대비덤프

Pass4Test에서는 소프트웨어버전과 PDF버전 두가지버전으로 VMware Certification VCI550덤프를 제공해드립니다.PDF버전은 구매사이트에서 무료샘플을 다움받아 체험가능합니다. 소프트웨어버전은 실력테스트용으로 PDF버전공부후 보조용으로 사용가능합니다. VMware Certification VCI550덤프 무료샘플을 다운받아 체험해보세요.

 

NO.1 An administrator receives notice of a large number of ARP table issues. The issues began after a
maintenance window 36 hours ago. The issue did not exist prior to the maintenance window.
Which change was made to the port group that is causing the ARP table issue?
A. Notify Switches was changed to No.
B. Uplink 2 was changed from Standby to Active.
C. Failback was changed to Yes.
D. Network failure detection was changed to Link status only.
Answer: A

NO.2 What should an administrator do to configure multi-pathing using software iSCSI?
A. Bind the VMkernel ports to the software iSCSI initiator
B. Configure Zoning between the hosts and SAN switches
C. Configure NIC teaming on the associated uplinks
D. Ensure jumbo frames are enabled end-to-end
Answer: A

NO.3 During the installation of ESXi, a vmkernel interface can be configured with what capabilities?
A. Management traffic
B. Management traffic and vMotion
C. Management traffic, vMotion and Fault Tolerance logging
D. Management traffic, vMotion, Fault Tolerance logging and IP storage
Answer: A

NO.4 A VMware administrator determines that a low priority virtual machine is negatively affecting
the disk I/O performance of a higher priority virtual machine. The virtual machines are hosted on the
same datastore presented to the same ESXi host.
Which configuration option should the VMware administrator use to resolve this issue?
A. Increase the disk share value for the high priority VM.
B. Migrate the low priority VM to another ESXi host.
C. Create a Storage Profile for each priority level.
D. Enable vSphere APIs for Array Integration (VAAI).
Answer: A

NO.5 An administrator is migrating 135 virtual machines from a vSphere Standard Switch to a
vSphere Distributed switch. The migration reports an error and only some of the virtual machines are
transferred.
What is causing the error to occur?
A. The vSphere Distributed Switch was created with a single, default port group.
B. The switch has become disconnected from an ESXi host.
C. The port group on the vSphere Distributed Switch was not configured with an Elastic port binding.
D. The virtual machine that failed to transfer did not have a network adapter.
Answer: A

NO.6 An administrator is planning a vSphere Fault Tolerance implementation for 6 virtual machines.
Which two virtual disk types are supported with FT? (Choose two.)
A. Raw Device Mapped LUN configured for Virtual Compatibility Mode
B. Raw Device Mapped LUN configured for Physical Compatibility Mode
C. Virtual disk thick provisioned, eager zeroed
D. Virtual disk thick provisioned, lazy zeroed
Answer: A,C

NO.7 An administrator has configured hardware acceleration for a Fibre Channel storage array. After
a recent maintenance event, the administrator finds that cloning and migration operations are taking
excessively long to complete.
Which two settings could cause hardware acceleration to become disabled? (Choose two.)
A. VAAI Plugin Name = VMW_VAAIP_SYM
B. VAAI Plugin Name = VMW_VAAIP_NETAPP
C. VMFS3.HardwareAcceleratedLocking = 0
D. Datamover.HardwareAcceleratedInit = 0
Answer: C,D

NO.8 A vSphere administrator is attempting to migrate a virtual machine, but the progress bar for the
migration remains at 10%.
Which issue could be preventing the vMotion migration?
A. A networking problem between the source and destination hosts exists at the physical layer.
B. The virtual machine is not on shared storage visible to the source and destination hosts.
C. The vMotion migration priority for this migration was set to High.
D. The vMotion network is saturated.
Answer: A

Posted 2014/12/19 9:59:15  |  Category: VMware  |  Tag: VCI550인증대비덤프