IT인증,IT자격증,IT자격증시험,IT인증시험

http://www.pass4test.net/

Cisco 400-101덤프데모

Pass4Test덤프공부가이드는 업계에서 높은 인지도를 자랑하고 있습니다. Pass4Test제품은 업데이트가 가장 빠르고 적중율이 가장 높아 업계의 다른 IT공부자료 사이트보다 출중합니다. Pass4Test의  Cisco 400-101 (CCIE Routing and Switching Written Exam) 덤프는 이해하기 쉽고 모든  Cisco 400-101 (CCIE Routing and Switching Written Exam) 시험유형이 모두 포함되어 있어 덤프만 잘 이해하고 공부하시면 Cisco 400-101 (CCIE Routing and Switching Written Exam) 시험패스는 문제없습니다.







NO.1 Which statement is true regarding UDLD and STP timers?

A. The UDLD
message timer should be two times the STP forward delay to prevent loops.

B.
UDLD and STP are unrelated features, and there is no relation between the
timers.

C. The timers need to be synced by using the spanning-tree udld-sync
command.

D. The timers should be set in such a way that UDLD is detected
before the STP forward delay

expires.

Answer: D



NO.2 Which two
tunneling techniques determine the IPv4 destination address on a per-packet
basis?

(Choose two.)

A. 6to4 tunneling

B. ISATAP tunneling

C. manual
tunneling

D. GRE tunneling

Answer: A,B



NO.3 Which two options are
causes of out-of-order packets? (Choose two.)

A. a routing loop

B. a
router in the packet flow path that is intermittently dropping packets

C.
high latency

D. packets in a flow traversing multiple paths through the
network

E. some packets in a flow being process-switched and others being
interrupt-switched on a

transit router

Answer: D,E



NO.4 Refer to
the exhibit.

The interface FastEthernet0/1 of both routers R4 and R5 is
connected to the same Ethernet segment

with a multicast receiver. Which two
statements are true? (Choose two)

A. Multicast traffic that is destined to a
receiver with IP address 192.168.2.6 will flow through router

R4.

B. Both
routers R4 and R5 will send PIM join messages to the RP.

C. Only router R5
will send a multicast join message to the RP.

D. Multicast traffic that is
destined to a receiver with IP address 192.168.2.6 will flow through
router

R5.

Answer: C,D



NO.5 A service provider is deploying L2VPN
LAN services in its MPLS cloud. Which statement is true

regarding LDP
signaling and autodiscovery?

A. LDP signaling requires that each PE is
identified, and that an LDP session is active with its P

neighbor for
autodiscovery to take place.

B. LDP signaling requires that each P is
identified, and that a targeted LDP session is active for

autodiscovery to
take place.

C. LDP signaling requires that each PE is identified, and that a
targeted LDP session with a BGP route

reflector is active for autodiscovery
to take place.

D. LDP signaling requires that each PE is identified, and that
a targeted LDP session is active for

autodiscovery to take place.

Answer:
D



NO.6 Which two hashing algorithms can be used when configuring SNMPv3?
(Choose two.)

A. MD5

B. SHA-1

C. Blowfish

D. DES

E. AES

F.
SSL

Answer: A,B



NO.7 Refer to the exhibit.

Why is the neighbor
relationship between R1 & R2 and R1 & R3 an L2-type neighborship?

A.
because the area ID on R1 is different as compared to the area ID of R2 and
R3

B. because the circuit type on those three routers is L1/L2

C. because
the network type between R1, R2, and R3 is point-to-point

D. because the
hello interval is not the same on those three routers

Answer: A



NO.8
Which three EIGRP packet types are valid? (Choose three.)

A. open

B.
notification

C. keep-alive

D. hello

E. query

F. reply

Answer:
D,E,F



Posted 2014/12/17 11:24:18  |  Category: cisco  |  Tag: 400-101덤프데모