Pass4Test의 Motorola Solutions Certification MSC-241 덤프는 시험패스율이 거의 100%에 달하여 많은 사랑을 받아왔습니다. 저희 사이트에서 처음 구매하는 분이라면 덤프풀질에 의문이 갈것입니다. 여러분이 신뢰가 생길수 있도록 Pass4Test에서는 Motorola Solutions Certification MSC-241덤프구매 사이트에 무료샘플을 설치해두었습니다.무료샘플에는 5개이상의 문제가 있는데 구매하지 않으셔도 공부가 됩니다. Motorola Solutions Certification MSC-241덤프로  Motorola Solutions Certification MSC-241시험을 준비하여 한방에 시험패하세요.

 

 

NO.1 Which of the following are TRUE statements about operating a MOTOTRBO repeater in a

Capacity Plus configuration?

A. One of its logical channels can work in trunked mode and the other logical channel can work in

data revert mode.

B. Both logical channels can work in trunked mode.

C. Both logical channels can work in data revert mode.

D. Only A & B are true (C is false)

E. Only B & C are true (A is false)

F. A, B, & C are true

Answer: F

 

NO.2 What changes are required to the Master Repeater in an IP Site Connect system when a new

peer

is added to the system?

A. Both the IP address and port number of the new repeater must be configured into the Master

Repeater.

B. The address of the new peer must be configured into the Master Repeater.

C. The port of the new peer must be configured into the Master Repeater.

D. No changes are required to the Master Repeater.

Answer: D

 

NO.3 You are looking to optimize battery life of radios that are close to the base station. Which is

the

most likely parameter for optimizing the battery life of a radio for a Capacity Plus system?

A. Beacon interval

B. Beacon duration

C. High power mode in Radio

D. Low power mode in Radio

Answer: D

 

NO.4 What will Enhanced Channel Access improve?

A. The amount of GPS updates that can be sent on a data revert channel

B. The amount of time from when PTT is pressed until voice is sent

C. Call success rate

D. Call setup time

Answer: C

 

NO.5 A Capacity Plus system consists of three (3) repeaters with repeater one (1) the master and

repeaters two (2) and three (3) as peers. On the 24th of May, there is a lighting strike at the site

and the building lost power, causing the three repeaters to revert to DC power. The design of the

site called for just the repeaters to be battery backed. However the next morning the customer

calls and reports that a number of talkgroups are getting busy tones (engaged), yet other groups

are seeing no busy tones (engaged) on the system. Which of the following statements BEST

describe the issue?

A. The master has gone down and taken the rest of the Capacity Plus network with it.

B. The peers use DHCP and were not able to connect to the master and refresh their peer list and

went off the Capacity Plus network as their leases expired.

C. The switch was not on battery backup and there are no LAN connections on the Capacity Plus

system, each of the repeaters are now operating as three (3) independent Capacity Plus systems.

D. The peers use DHCP and were not able to connect to the master and refresh their peer list.

The dealer should have used static IP addresses throughout.

Answer: C

 

NO.6 On which type of channel in an IP Site Connect system are Transmit Interrupt features

supported

in repeater firmware releases R01.08.00 and higher?

A. Wide Area Slots only

B. Local Area Slots only

C. Both Wide and Local Area slots

D. Noneoftheabove

Answer: D

 

NO.7 Which of the following are TRUE statements about operating a MOTOTRBO repeater in an IP

Site

Connect configuration?

A. One of its logical channels can work in IP Site Connect mode (over wide area) and the other

logical channel can work in digital repeater mode (single site over local area).

B. Both logical channels can work in digital repeater mode (single site over local area).

C. Both logical channels can work in IP Site Connect mode (over wide area).

D. Only A and B are true (C is false).

E. Only A and C are true (B is false).

F. A, B, and C are true.

Answer: F

 

NO.8 A Capacity Plus system consists of three (3) repeaters with repeater one (1) the master and

repeaters two (2) and three (3) as peers. The dealer needs to make a simple change in repeater

two (2) and utilize IP repeater programming (IRP) to access the repeater remotely. A couple of

days later the customer calls and complains about users getting system busy tones (engaged

tones).

The dealer attempts to connect an RDAC remotely to the system with no success. He has verified

he can communicate to the router at the site.

Which of the following statements BEST describes the issue?

A. The master has gone down and taken the rest of the Capacity Plus network with it.

B. The master has gone down and the system is operating on just two (2) repeaters.

C. There is RF interference on the channel and the master repeater is unable to communicate to

the peers.

D. The peers are using DHCP and are not able to connect to the master and refresh their peer list.

The system is operating on just the master.

Answer: B

 

NO.9 Which of the following antennas is BEST suited for providing coverage inside a tall building?

A. 4 element Yagi

B. Radiating coaxial cable

C. End-fed half-wave antenna

D. High gain collinear antenna

Answer: B

 

NO.10 A MOTOTRBO repeater is connected to a Zetron Model 35 Telephone Interconnect. If a

telephone

user dials the Telephone Interconnect number, they get a busy signal (engaged tone). If a radio

user dials any telephone number, they don’t hear the ringing tone, only silence. Upon visiting the

site, you find that when a radio user dials, the relay click can be heard from the Zetron Model 35.

Unplugging the RJ11 and dialing the Telephone Interconnect, still results in a busy signal

(engaged tone). With this information, what do you think could be wrong?

A. The Zetron Model 35 may be faulty.

B. The Zetron Model 35 has probably not been configured for the phone line Ringer Equivalence

Number (REN).

C. The RJ11 cable may have a short circuit or there is a short circuit somewhere between the site

and the exchange.

D. The repeater interface cable to the Zetron Model 35 is faulty.

Answer: C