수많은 Motorola Solutions Certification MSC-241시험공부자료중에서 Pass4Test의 Motorola Solutions Certification MSC-241덤프가 가장 출중한 원인은 무엇일가요? Pass4Test의 Motorola Solutions Certification MSC-241덤프는 실제시험문제의 출제방향을 연구하여 IT전문가로 되어있는 덤프제작팀이 만든 최신버전 덤프입니다. Pass4Test의 Motorola Solutions Certification MSC-241덤프가 있으면 힘든Motorola Solutions Certification MSC-241시험이 쉬어져서 자격증을 제일 빠른 시간내에 취득할수 있습니다.제일 어려운 시험을 제일 간단한 방법으로 패스하는 방법은 Pass4Test의 Motorola Solutions Certification MSC-241덤프로 시험준비 공부를 하는것입니다.
NO.1 What changes are required to the Master Repeater in an IP Site Connect system when a new
peer
is added to the system?
A. Both the IP address and port number of the new repeater must be configured into the Master
Repeater.
B. The address of the new peer must be configured into the Master Repeater.
C. The port of the new peer must be configured into the Master Repeater.
D. No changes are required to the Master Repeater.
Answer: D
NO.2 You are looking to optimize battery life of radios that are close to the base station. Which is
the
most likely parameter for optimizing the battery life of a radio for a Capacity Plus system?
A. Beacon interval
B. Beacon duration
C. High power mode in Radio
D. Low power mode in Radio
Answer: D
NO.3 Which of the following are TRUE statements about operating a MOTOTRBO repeater in an IP
Site
Connect configuration?
A. One of its logical channels can work in IP Site Connect mode (over wide area) and the other
logical channel can work in digital repeater mode (single site over local area).
B. Both logical channels can work in digital repeater mode (single site over local area).
C. Both logical channels can work in IP Site Connect mode (over wide area).
D. Only A and B are true (C is false).
E. Only A and C are true (B is false).
F. A, B, and C are true.
Answer: F
NO.4 Which of the following are TRUE statements about operating a MOTOTRBO repeater in a
Capacity Plus configuration?
A. One of its logical channels can work in trunked mode and the other logical channel can work in
data revert mode.
B. Both logical channels can work in trunked mode.
C. Both logical channels can work in data revert mode.
D. Only A & B are true (C is false)
E. Only B & C are true (A is false)
F. A, B, & C are true
Answer: F
NO.5 What will Enhanced Channel Access improve?
A. The amount of GPS updates that can be sent on a data revert channel
B. The amount of time from when PTT is pressed until voice is sent
C. Call success rate
D. Call setup time
Answer: C
NO.6 A MOTOTRBO repeater is connected to a Zetron Model 35 Telephone Interconnect. If a
telephone
user dials the Telephone Interconnect number, they get a busy signal (engaged tone). If a radio
user dials any telephone number, they don’t hear the ringing tone, only silence. Upon visiting the
site, you find that when a radio user dials, the relay click can be heard from the Zetron Model 35.
Unplugging the RJ11 and dialing the Telephone Interconnect, still results in a busy signal
(engaged tone). With this information, what do you think could be wrong?
A. The Zetron Model 35 may be faulty.
B. The Zetron Model 35 has probably not been configured for the phone line Ringer Equivalence
Number (REN).
C. The RJ11 cable may have a short circuit or there is a short circuit somewhere between the site
and the exchange.
D. The repeater interface cable to the Zetron Model 35 is faulty.
Answer: C
NO.7 On which type of channel in an IP Site Connect system are Transmit Interrupt features
supported
in repeater firmware releases R01.08.00 and higher?
A. Wide Area Slots only
B. Local Area Slots only
C. Both Wide and Local Area slots
D. Noneoftheabove
Answer: D
NO.8 Which of the following antennas is BEST suited for providing coverage inside a tall building?
A. 4 element Yagi
B. Radiating coaxial cable
C. End-fed half-wave antenna
D. High gain collinear antenna
Answer: B
NO.9 A Capacity Plus system consists of three (3) repeaters with repeater one (1) the master and
repeaters two (2) and three (3) as peers. On the 24th of May, there is a lighting strike at the site
and the building lost power, causing the three repeaters to revert to DC power. The design of the
site called for just the repeaters to be battery backed. However the next morning the customer
calls and reports that a number of talkgroups are getting busy tones (engaged), yet other groups
are seeing no busy tones (engaged) on the system. Which of the following statements BEST
describe the issue?
A. The master has gone down and taken the rest of the Capacity Plus network with it.
B. The peers use DHCP and were not able to connect to the master and refresh their peer list and
went off the Capacity Plus network as their leases expired.
C. The switch was not on battery backup and there are no LAN connections on the Capacity Plus
system, each of the repeaters are now operating as three (3) independent Capacity Plus systems.
D. The peers use DHCP and were not able to connect to the master and refresh their peer list.
The dealer should have used static IP addresses throughout.
Answer: C
NO.10 A Capacity Plus system consists of three (3) repeaters with repeater one (1) the master and
repeaters two (2) and three (3) as peers. The dealer needs to make a simple change in repeater
two (2) and utilize IP repeater programming (IRP) to access the repeater remotely. A couple of
days later the customer calls and complains about users getting system busy tones (engaged
tones).
The dealer attempts to connect an RDAC remotely to the system with no success. He has verified
he can communicate to the router at the site.
Which of the following statements BEST describes the issue?
A. The master has gone down and taken the rest of the Capacity Plus network with it.
B. The master has gone down and the system is operating on just two (2) repeaters.
C. There is RF interference on the channel and the master repeater is unable to communicate to
the peers.
D. The peers are using DHCP and are not able to connect to the master and refresh their peer list.
The system is operating on just the master.
Answer: B