성공으로 향하는 길에는 많은 방법과 방식이 있습니다. Cisco 100-101 (CCNA Interconnecting Cisco Networking Devices 1 (ICND1))시험을 패스하는 길에는 Pass4Test의 Cisco 100-101 (CCNA Interconnecting Cisco Networking Devices 1 (ICND1))덤프가 있습니다. Pass4Test의 Cisco 100-101 (CCNA Interconnecting Cisco Networking Devices 1 (ICND1))덤프는 실제시험 출제방향에 초점을 두어 연구제작한 시험준비공부자료로서 높은 시험적중율과 시험패스율을 자랑합니다.국제적으로 승인해주는 IT자격증을 취득하시면 취직 혹은 승진이 쉬워집니다.

NO.1 Which two characteristics describe the access layer of the hierarchical network design model?
(Choose two.)
A. layer 3 support
B. port security
C. redundant components
D. VLANs
E. PoE
Answer: B,D

NO.2 Which statements accurately describe CDP? (Choose three.)
A. CDP is an IEEE standard protocol.
B. CDP is a Cisco proprietary protocol.
C. CDP is a datalink layer protocol.
D. CDP is a network layer protocol.
E. CDP can discover directly connected neighboring Cisco devices.
F. CDP can discover Cisco devices that are not directly connected.
Answer: B,C,E

NO.3 Refer to the exhibit.
Which command would you use to configure a static route on Router1 to network 192.168.202.0/24
with a nondefault administrative distance?
A. router1(config)#ip route 1 192.168.201.1 255.255.255.0 192.168.201.2
B. router1(config)#ip route 192.168.202.0 255.255.255.0 192.168.201.2 1
C. router1(config)#ip route 5 192.168.202.0 255.255.255.0 192.168.201.2
D. router1(config)#ip route 192.168.202.0 255.255.255.0 192.168.201.2 5
Answer: D

NO.4 Refer to the exhibit.
The junior network support staff provided the diagram as a recommended configuration for the first
phase of a four-phase network expansion project. The entire network expansion will have over 1000
users on 14 network segments and has been allocated this IP address space.
192.168.1.1 through 192.168.5.255
192.168.100.1 through 192.168.100.255
What are three problems with this design? (Choose three.)
A. The AREA 1 IP address space is inadequate for the number of users.
B. The AREA 3 IP address space is inadequate for the number of users.
C. AREA 2 could use a mask of /25 to conserve IP address space.
D. The network address space that is provided requires a single network-wide mask.
E. The router-to-router connection is wasting address space.
F. The broadcast domain in AREA 1 is too large for IP to function.
Answer: A,C,E

NO.5 Which IOS command is used to initiate a login into a VTY port on a remote router?
A. router# login
B. router# telnet
C. router# trace
D. router# ping
E. router(config)# line vty 0 5
F. router(config-line)# login
Answer: B

NO.6 Refer to the output of the corporate router routing table shown in the graphic.
The corporate router receives an IP packet with a source IP address of 192.168.214.20 and a
destination address of 192.168.22.3.
What will the router do with this packet?
A. It will encapsulate the packet as Frame Relay and forward it out interface Serial 0/0.117.
B. It will discard the packet and send an ICMP Destination Unreachable message out interface
FastEthernet 0/0.
C. It will forward the packet out interface Serial 0/1 and send an ICMP Echo Reply message out
interface serial 0/0.102.
D. It will change the IP packet to an ARP frame and forward it out FastEthernet 0/0.
Answer: B

NO.7 Given an IP address of 192.168.1.42 255.255.255.248, what is the subnet address?
A. 192.168.1.8/29
B. 192.168.1.32/27
C. 192.168.1.40/29
D. 192.168.1.16/28
E. 192.168.1.48/29
Answer: C

NO.8 A switch receives a frame on one of its ports. There is no entry in the MAC address table for the
destination MAC address. What will the switch do with the frame?
A. drop the frame
B. forward it out of all ports except the one that received it
C. forward it out of all ports
D. store it until it learns the correct port
Answer: B