네트워크 관련 자격증

- CISCO 사 국제 자격증 CCNA (초급), CCNP (중급), CCIE (고급)

 

 

Pass4Test는   CCIE Data Center 350-080 (CCIE Data Center Written Exam) 시험문제가 변경되면  CCIE Data Center 350-080 (CCIE Data Center Written Exam) 덤프업데이트를 시도합니다. 업데이트가능하면 바로 업데이트하여 업데이트된 최신버전을 무료로 제공해드리는데 시간은 1년동안입니다.  CCIE Data Center 350-080 (CCIE Data Center Written Exam) 시험을 패스하여 자격증을 취득하고 싶은 분들은 Pass4Test제품을 추천해드립니다.온라인서비스를 찾아주시면 할인해드릴게요. CCIE Data Center 350-080 (CCIE Data Center Written Exam) 시험패스 공부방법을 찾고 있다면 제일 먼저 Pass4Test를 추천해드리고 싶습니다.  CCIE Data Center 350-080 (CCIE Data Center Written Exam) 시험이 많이 어렵다는것은 모두 알고 있는 것입니다. Pass4Test에서 출시한  CCIE Data Center 350-080 (CCIE Data Center Written Exam) 덤프는 실제시험을 대비하여 연구제작된 멋진작품으로서   CCIE Data Center 350-080 (CCIE Data Center Written Exam) 시험적중율이 최고입니다.  CCIE Data Center 350-080 (CCIE Data Center Written Exam) 시험패스를 원하신다면Pass4Test의 제품이 고객님의  소원을 들어줄것입니다.

 

 

NO.1 Refer to the exhibit.
Cisco Nexus 7000 switches are deployed in a redundant configuration at the distribution layer of the data
center network. The network administrator configured all the trunk ports on the distribution layer to allow
VLAN 3 and created a VLAN interface with an IP address of 10.10.10.1/24. When the status of the
interface VLAN 3 is checked, it is shown as "Vlan3 is down, line protocol is down."
What is a likely cause of this problem?
A. The VLAN interface is not allowed in Cisco NX-OS.
B. The issue is related to software licensing.
C. Loopback is not set.
D. A VLAN is not created on the switch.
Answer: B

NO.2 What does the previously active supervisor do when "system switchover" is issued?
A. State is transferred and then becomes ha-standby.
B. A core dump file is written, state is transferred, and the system resets.
C. State is transferred; the supervisor reloads and becomes ha-standby.
D. State is transferred; data plane operations are briefly suspended and then become ha-standby.
Answer: C

NO.3 On a 32-port 10 Gigabit Ethernet module, each set of four ports can handle 10 Gb/s of bandwidth. What
can you use the rate-mode parameter for?
A. to limit the speed on any port
B. to dedicate all the group bandwidth to the first port
C. to dedicate all the group bandwidth to the last port
D. to limit the speed on all ports
Answer: B

NO.4 Which option protects the supervisor engine against one class of traffic hitting too heavily on the
supervisor CPU, which leads to too many CPU resources being used?
A. SNMP
B. CoPP
C. ACL
D. Telnet
Answer: B

NO.5 A Cisco Nexus 7000 switch is used with the VRF feature to provide separation between the inside and
outside interfaces of a transparent firewall. The VRF RED is used for an untrusted network of the virtual
data center, and it is connected to the outside interface of the firewall. The VRF GREEN is used as a
trusted network of the virtual data center and is connected to the inside interface of the firewall. Subnet
10.10.10.0/20 is used to communicate between two VRFs across the transparent firewall. The firewall is
configured correctly. The network administrator configured the VRFs and IP addressing correctly, but you
are still unable to communicate across the firewall.
What is a likely cause of the problem?
A. This topology is incorrect. A transparent firewall cannot be used with VRF.
B. On Cisco Nexus 7000, policy-based routing is required to communicate between two VRFs.
C. The issue is related to software licensing; an Enterprise Services license is required on Cisco Nexus
7000.
D. The issue is related to the MAC address of the SVI.
E. The issue is related to keepalive, which is not supported on the SVI.
Answer: D

NO.6 Which FEX supports FCoE?
A. N2232PP
B. N2224TP
C. N2232TM
D. N2148T
Answer: A

NO.7 Which component of the Cisco Nexus 7010 architecture provides out-of-band management, an
always-on microprocessor for disaster recovery, and remote restart capabilities?
A. central arbiter
B. Connectivity Management Processor
C. supervisor engine
D. dedicated service modules
Answer: B

NO.8 On a Cisco Nexus 7000, a CoPP can be applied separately to each VDC.
A. True
B. False
Answer: B

NO.9 Which two options describe virtualized multi-tenancy? (Choose two.)
A. dedicated infrastructure for each tenant
B. shares a common infrastructure between tenants
C. agreement between tenants with rules about sharing DC resources
D. tenants using virtualization technologies to separate from each other
E. data centers using virtualization technologies to separate tenants
Answer: B,E

NO.10 Refer to the exhibit.
Identify the correct placement of spanning tree features in the data center topology.
A. RED = bpdu guard, GREEN = root guard, YELLOW = loop guard
B. RED = bpdu guard, GREEN = loop guard, YELLOW = bridge assurance
C. RED = bpdu guard/portfast, GREEN = loop guard, YELLOW = root guard
D. RED = bpdu guard/portfast, GREEN = root guard, YELLOW = loop guard
Answer: C

NO.11 Refer to the exhibit.
Grace LSAs are generated by a router that wishes to execute a graceful restart of its OSPF process. A
grace LSA requests neighbors to continue advertising the router as fully adjacent during a specified grace
period.
What are two TLVs that must always appear in the body of a grace LSA? (Choose two.)
A. Grace Period (Type=1, length=4)
B. Graceful Restart Reason (Type=2, length=1)
C. IP Interface Address (Type=3, length=4)
D. Router ID (Type=1, length=4)
Answer: A,B

NO.12 In a Cisco Nexus 5000, the multicast scheduling algorithm can operate in how many modes?
A. 1
B. 2
C. 3
D. 4
Answer: B

NO.13 Which option describes what takes place when a "storage" VDC is created on Nexus 7000?
A. All M series modules in the VDC are powered down.
B. FCoE VLANs are allocated and interfaces are shared with LAN VDCs.
C. The module type is limited to F1/F2, and the ability to share interfaces is enabled.
D. FCoE is installed and F1/F2 modules are licensed for FCoE use.
Answer: C

NO.14 Which three components does a data center network layer have? (Choose three.)
A. Cisco GSR
B. Cisco CRS-1
C. Cisco Nexus 7000
D. Cisco Nexus 1000V
E. Cisco Nexus 2000
F. Cisco ASR 9000
G. Cisco Nexus 5000
Answer: C,E,G

NO.15 Which tasks can be performed only in the default VDC?
A. EPLD upgrade, Cisco IOS ISSU, FCoE feature enablement, CoPP configuration, and rolling back a
checkpoint
B. EPLD upgrade, Cisco IOS ISSU, FCoE feature enablement, CoPP configuration, and SNMP
configuration
C. EPLD upgrade, Cisco IOS ISSU, FCoE feature enablement, CoPP configuration, and ACL capture
enablement
D. EPLD upgrade, Cisco IOS ISSU, FCoE feature enablement, CoPP configuration, and write erase
Answer: C

NO.16 Refer to the components below. Which data center design layer contains these components?
-Cisco UCS 6100 Fabric Interconnect
-Cisco Nexus 1000V
-Cisco UCS 5100 Blade Chassis
A. the Virtualization layer
B. the Management layer
C. the Compute layer
D. the Services layer
Answer: C

NO.17 Cisco Nexus 5000 Series Switches are best positioned at which layer?
A. access layer, as an end-of-row switch for FCIP and iSCSI aggregation
B. distribution layer, with multiples of 10 Gb/s ports
C. access layer, as a top-of-rack switch for server I/O consolidation with FCoE
D. aggregation layer, supporting virtual security and application services
Answer: C

NO.18 Which three statements best describe the Cisco Unified Fabric solution for the data center? (Choose
three.)
A. Cisco Nexus 5000 Series Switches provide the capability to consolidate LAN and SAN traffic on a
unified fabric over Ethernet.
B. The unified fabric is delivered through technologies such as FCoE and DCB.
C. FCoE allows transmission of Fibre Channel traffic over Ethernet by encapsulating native Fibre Channel
frames into GRE and transporting them across the Ethernet network.
D. FCoE allows consolidating Fibre Channel traffic from multiple VSANs into the same Ethernet VLAN to
be transported across the fabric. PFC ensures lossless transport of the FC traffic over Ethernet.
E. PFC allows user priorities to be defined on a single physical link, each of which can have its own logical
lane that can be paused independently of the others.
Answer: A,B,E

NO.19 Which two Cisco devices form the virtual access layer in the Cisco Data Center Architecture? (Choose
two.)
A. Cisco Nexus 7000
B. Cisco Nexus 5000
C. Cisco Nexus 1010
D. Cisco Nexus 2000
E. Cisco Nexus 1000V
Answer: C,E

NO.20 The persistent storage service (PSS) is used by which function?
A. storage of log files across reloads of the system
B. storage of license files in the backplane EEPROM
C. storage of the process-specific state for stateful process recovery
D. storage of core dump files from crashed processes
Answer: C