Pass4Test 의 Riverbed 299-01 (Riverbed Certified Solutions Professional - Network Performance Management) 덤프는  Riverbed 299-01 (Riverbed Certified Solutions Professional - Network Performance Management) 시험에 도전장을 던진 분들이 신뢰할수 있는 든든한 길잡이 입니다. Riverbed 299-01 (Riverbed Certified Solutions Professional - Network Performance Management) 시험대비 덤프뿐만아니라 다른 IT인증시험에 대비한 덤프자료도 적중율이 끝내줍니다. Riverbed 299-01 (Riverbed Certified Solutions Professional - Network Performance Management) 시험이나 다른 IT인증자격증시험이나 Pass4Test제품을 사용해보세요.투자한 덤프비용보다 훨씬 큰 이득을 보실수 있을것입니다.

NO.1 For DNS reverse lookup, Cascade Profiler caches as follows:

A. Cache the most recent 500 IPs.

B. Obey DNS TTLs.

C. Cascade does not cache DNS responses.

D. For 24 hours.

Answer: C

NO.2 What are the two types of dashboards available within the Cascade Profiler GUI? (select 2)

A. Top Hosts

B. Top Applications

C. Public

D. Private

E. Devices and Interfaces Utilization

Answer: C,D

NO.3 If a VLAN SPAN (VLAN101) is configured and monitored by Cascade Shark, which of the

following is true? (Select 2)

A. Inter VLAN101 traffic will be monitored; Intra VLAN101 traffic will not.

B. Intra VLAN101 traffic will be monitored; Inter VLAN101 traffic will not.

C. Both inter and intra VLAN101 traffic will be monitored.

D. It is a best practice to configure the Cascade Shark monitoring port (the SPAN destination) with

'deduplication' enabled.

E. It is a best practice to configure the Cascade Shark monitoring port (the SPAN destination)

without

'deduplication' enabled.

Answer: C,D

NO.4 Which of the following configuration changes can be used to reduce the number of alerts

generated overall for a Service?

A. Edit each Service policy to increase the Tolerance slider for Low and High alerts.

B. Edit each Service policy and set a noise floor to specify the minimum amount of change that the

policy

can treat as deviation from normalbehavior.

C. Edit the Service and select fewer metrics to monitor for each segment that comprises the Service.

D. Modify the location host group type used for monitoring end user traffic to use fewer groups (for

example, Region instead of Site).

E. A, B, C, and D.

F. A and B only.

Answer: E

NO.5 Quality of Service information is obtained from what Cascade sources?

A. Cascade Sensor only

B. Cannot get QoS data on Cascade

C. Cascade Sensor and Cascade Gateway

D. CascadeFlow traffic only

E. NetFlow and IPFIX traffic only

Answer: C

NO.6 If a report table on Cascade Profiler includes the "Server Delay" column but shows no value

for

"Server Delay" in some cells, what are the possible causes? (Select 3)

A. The time span of the report does not cover any connection set-up points

B. Server delay is zero.

C. The protocol used by the application in not TCP-based.

D. Application traffic was not seen by a Cascade Sensor.

E. The server plug-in is needed to measure "Server Delay" and not functioning correctly.

Answer: A,C,D

NO.7 If unable to connect to the Cascade Shark Appliance from the Cascade Pilot console it could

be

because. (Select 2)

A. The correct communication port(s) are NOT open on the firewall between Cascade Pilot and

Cascade

Shark.

B. The Cascade Shark is placed in "passthru" mode so Cascade Pilot access is not available

C. The Cascade Shark appliance has no capture jobs configured.

D. You may be running Cascade Pilot-Personal-Edition (PE). You need the full version of Cascade

Pilot to

connect to Cascade Shark.

E. Trend/Index data is disabled on the Cascade Shark Appliance.

Answer: A,D

NO.8 When creating an analytic service, the discovery process requires a minimum of:

A. At least three days of data available.

B. At least three weeks of data available.

C. The application specialist available.

D. Some historical data and some starting point (a server, port, application).

E. A customer network diagram available.

Answer: D