Pass4test 덤프는 IT 전문가들이 IT인증시험 실제문제를 연구분석하여 제작한 가장 좋은 시험대비자료입니다. Juniper JN0-692 (Service Provider Routing and Switching Support, Professional) 시험은 높은 난이도로 이름있는 과목입니다. 이 Juniper JN0-692 (Service Provider Routing and Switching Support, Professional) 시험을 패스하여 인기자격증을 취득하시면 연봉협상이나 승진 혹은 이직에 많은 도움이 됩니다. Juniper JN0-692 (Service Provider Routing and Switching Support, Professional) 시험대비는 pass4test 덤프로 하면 최고입니다.
NO.1 One of your router's OSPF adjacencies is down.
What are three reasons for this adjacency state change? (Choose Three)
A. A filter has just been configured on one of the OSPF routers.
B. The OSPF hello value is the same on both routers.
C. The controlling BFD session state has gone down.
D. The authentication key on both routers matches.
E. One of the physical interfaces has gone down.
Answer: A,C,E
NO.2 You are asked to retain several routes from an external BGP neighbor in the routing table on
your local router, but you are not allowed to forward traffic to these destinations. You have
configured a forwarding table firewall filter to block these routes, and applied it under the (edit
forwarding-options] hierarchy, but the routes are still showing up in the forwarding table. What is
required to achieve this task?
A. Configure an EBGP import policy on your local router to block the routes.
B. Have the EBGP neighbor configure an export policy to block the routes.
C. Configure an export policy for the forwarding table to block the routes.
D. Use the no-install configuration statement within the EBGP neighbor group on your local router.
Answer: C
NO.3 Your currently configured regular expression does not match the AS path shown below:
2135.55 55 55 55 3796
Which three regular expressions would match this path? (Choose three.)
A. "."2135"
B. "2135.*"
C. "* 55(1, 3) *"
D. "2135 55(5) 3796"
E. "2135 55(1, 2) 3796"
Answer: B,C,E
NO.4 You have recently implemented a new Layer 2 VPN and it is not establishing. The show I2vpn
connections command displays an out-of-range state.
What is causing this problem?
A. The local site ID value is too high for the label block.
B. The VRF target community values do not match between sites.
C. The VRF route distinguisher values do not match between sites.
D. The local site ID is not defined.
Answer: A
NO.5 You have applied a customized EXP rewrite rule on router R1 on the egress of the interface
connecting to router R2. You want to verify if it is working properly. Which two methods would you
use to accomplish this task? (Choose two.)
A. Apply a rewrite rule on the ingress of R2 for packets coming in from R1 and count those packets
for the new EXP values with a firewall filter as they leave R2.
B. Use the traceroute utility.
C. Use an output filter on R1 that matches and counts on various EXP values on packets going to R2.
D. Use an input firewall filter on R2 that matches and counts on various EXP values on packets
coming from R1.
Answer: C,D
NO.6 Your OSPF network includes an NSSA. Which LSA type is injected into the NSSA by the ASBR?
A. Type 3
B. Type 5
C. Type 7
D. Type 9
Answer: C
NO.7 An OSPF neighbor between routers R1 and R2 is stuck in loading state on R2. What are two
causes? (Choose two.)
A. OSPF is not enabled on the interfaces.
B. A firewall filter is blocking OSPF hellos on both sides.
C. The R1 router has received a corrupted link-state request packet.
D. The interface MTU is mismatched between the routers.
Answer: C,D
NO.8 You recently added your autonomous system to an existing BGP confederation. You notice that
a route that had a local preference of 100 now has a local preference of 50. Which statement
explains the change?
A. BGP path attributes such as next hop, local preference, and MED are normally restricted to a
single AS but are allowed to propagate throughout the confederation's AS members.
B. The confederation has sub-ASs that require all IBGP routes to have a local preference of 50 or
below.
C. When your Junos devices joined the confederation, they lost IBGP connectivity to the route in
question; the local preference reverted to 50 once the BGP peering established.
D. The route is being shared through an EBGP peer, and the confederation is propagating the local
preference from the peer.
Answer: A
NO.9 You have recently added LDP-signaled VPLS to your network. The VPLS connections are
established and you have been asked to verify that the forwarding plane is working properly. Which
three commands would you use? (Choose three.)
A. ping mpls Idp <fec>
B. show vpls connections
C. traceroute mpls Idp <fec>
D. show vpls mac-table
E. show Idp statistics
Answer: A,C,D