Pass4Test 는 아주 우수한 IT인증자료사이트입니다. Pass4Test에서 여러분은  A+ 220-801 (CompTIA A+ Certification Exam)  인증시험관련 덤프를 얻을수 있습니다. Pass4Test 사이트에서 제공하는 A+ 220-801 (CompTIA A+ Certification Exam) 관련자료의 일부분 문제와 답 등 샘플을 무료로 다운받아 체험해볼 수 있습니다. 그리고 Pass4Test에서는 A+ 220-801 (CompTIA A+ Certification Exam) 자료구매 후 추후 업데이트되는 동시에 최신버전을 무료로 발송해드립니다. 우리는   A+ 220-801 (CompTIA A+ Certification Exam) 인증시험관련 모든 자료를 여러분들에서 제공할 것입니다. Pass4Test 의 IT전문 팀은 부단한 업계경험과 연구를 이용하여 정확하고 디테일 한 시험문제와 답으로 여러분이 아주 간단히   A+ 220-801 (CompTIA A+ Certification Exam)  시험을 패스할 수 있도록 최선을 다하고 있습니다.Pass4Test 의   A+ 220-801 (CompTIA A+ Certification Exam)  자료로 자신만만한 시험 준비 하시기를 바랍니다. 우리를 선택함으로 자신의 시간을 아끼는 셈이라고 생각하시면 됩니다. A+ 220-801 (CompTIA A+ Certification Exam) 로 빠른 시일내에 자격증 취득하시고  A+ 220-801 (CompTIA A+ Certification Exam)   IT업계중에 엘리트한 전문가로 되시기를 바랍니다.IT인증자격증만 소지한다면 일상생활에서 많은 도움이 될것입니다.하지만 문제는 어떻게  간단하게 시험을 패스할것인가 입니다. Pass4Test는 IT전문가들이 제공한 시험관련 최신 연구자료들을 제공해드립니다.Pass4Test을 선택함으로써 여러분은 성공도 선택한것이라고 볼수 있습니다.

 

 

NO.1 Which of the following tools are commonly used to remove dust and debris from inside a
computer?
(Select TWO).
A. Cotton and alcohol
B. Vacuum
C. Compressed air
D. Anti-bacterial surface cleaner
E. Feather duster
Answer: B,C

NO.2 Which of the following hard drive types would be considered the MOST likely to survive a
fall?
A. SCSI
B. Solid State
C. IDE
D. SATA
Answer: B

NO.3 Which of the following is the BEST way to explain RAID to a non-technical user?
A. RAID is a dynamic logical disk management system.
B. RAID uses multiple hard disks to increase performance and/or provide protection against data
loss.
C. RAID uses data striping to reduce hard drive write time and parity bits to reconstruct the data
from a
failed hard drive.
D. RAID stands for Redundant Array of Independent Disks .
Answer: B

NO.4 Which of the following will provide the BEST protection against power failures and data loss?
A. Auto-switching power supply
B. Uninterruptible power supply
C. Line conditioner
D. Surge suppressor
Answer: B

NO.5 Which of the following cable types has the MAXIMUM transfer rate of 1 Gbps?
A. CAT3
B. CAT5
C. CAT5e
D. CAT6
Answer: C

NO.6 Which of the following ports MUST be open to connect to a PC using RDP.?
A. 21
B. 80
C. 443
D. 3389
Answer: D

NO.7 Which of the following MUST be performed when installing a PCI sound card for use instead
of the
onboard sound?
A. Install drivers
B. Install additional memory
C. Configure the jumpers
D. Flash the BIOS
Answer: A

NO.8 Which of the following wireless standards is backwards compatible with 802.11g?
A. 802.11a
B. 802.11b
C. 802.11n
D. 802.1q
Answer: C

NO.9 Which of the following is the MAXIMUM transfer speed of USB 2.0?
A. 100 Mbps
B. 400 Mbps
C. 420 Mbps
D. 480 Mbps
Answer: D

NO.10 Which of the following is representative of a class C address type?
A. 10.15.1.4
B. 169.254.125.15
C. 172.20.15.5
D. 192.168.1.15
Answer: D

NO.11 Which of the following is the BEST protocol to use for securely transferring large files?
A. Telnet
B. SSH
C. SFTP
D. FTP
Answer: C

NO.12 Which of the following display connections has 15-pins?
A. RGB
B. VGA
C. DVI
D. HDMI
Answer: B

NO.13 Which of the following connector types is only used for Coaxial?
A. RJ-11
B. ST
C. F
D. RJ-45
Answer: C

NO.14 Which type of fire extinguishing technology should be used when encountering an electrical
fire?
A. Class B fire extinguishers
B. Overhead sprinkler system
C. Water-based fire extinguishers
D. Non-water based extinguishers
Answer: D

NO.15 Which of the following is a public IP address?
A. 10.0.0.1
B. 62.10.1.1
C. 172.16.0.1
D. 192.168.1.1
Answer: B

NO.16 Which of the following is the speed limitation for CAT3 wiring?
A. 1 Mbps
B. 10 Mbps
C. 100 Mbps
D. 1000 Mbps
Answer: B

NO.17 Which of the following types of RAM can be used in a dual channel configuration?
A. SDRAM
B. RAMBUS
C. DDR
D. DIMM
Answer: C

NO.18 Which of the following features of Windows allows a device to have a default IP address if a
DHCP
server is not available?
A. APIPA
B. ARP
C. IPv6
D. DNS
Answer: A

NO.19 Which of the following are the MOST important factors to address when a technician is
choosing
the components for a CAD workstation? (Select THREE).
A. Large drive space allocation
B. Powerful sound card
C. Multiple network cards
D. Multiple large HD monitors
E. Powerful video card
F. Maximum RAM
G. Powerful processor
Answer: E,F,G

NO.20 A client wants a technician to install more RAM on their graphics workstation. The client has
provided a 4 GB SODIMM and had problems installing it.
Which of the following is the probable reason for this?
A. Graphic workstations require flash memory
B. The memory is incompatible for the workstation
C. Graphic workstations require solid state memory
D. The workstation has no available memory slots
Answer: B