아직도 어떻게 하면 Cisco 640-721 (Implementing Cisco Unified Wireless Networking Essentials (IUWNE)) 인증시험을 빠르게 취득할 수 있는 방법을 못찾고 계십니까? Cisco 640-721 (Imple menting Cisco Unified Wireless Networking Essentials (IUWNE)) 자료는 충분한 시험대비 자료가될 것입니다. 안심하시고 Pass4Test가 제공하는 제품을 사용하시고 100%통과 율을 확신합니다.다른 사이트에서도  Cisco 640-721 (Implementing Cisco Unified Wireless Networking Essen tials (IUWNE))  인증시험 관련 자료를 보셨다고 믿습니다.Pass4Test의 자료는 차원이 다른 완벽한 자료입니다.100%통과율은 물론 Pass4Test을 선택으로 여러분의 직장생활에 더 낳은 개변을가져다 드립니다.지금 Pass4Test에서 Cisco 640-721 (Implementing Cisco Unified Wireless Netw  orking Essentials (IUWNE)) 인증시험을 안전하게 넘을 수 있도록 대책을 내드리겠습니다. 아주신기한 효과가 있을 것입니다.Pass4Test에는 전문적인 업계인사들이   Cisco 640-721 (Implem enting Cisco Unified Wireless Networking Essentials (IUWNE)) 시험문제와 답에 대하여 연구하여 시험준비중인 여러분들한테 유용하고 필요한 시험가이드를 제공합니다. 만약 Pass4Test의 제품을 구매하려면 우리Pass4Test에서는 아주 디테일 한 설명과 최신버전 최고품질의 자료를 적중율이 높은 문제와 답을 제공합니다.

 

 

NO.1 Lightweight access points send control traffic to which device(s)?
A. Other access points.
B. The Wireless Control System.
C. The Wireless Controller.
D. Lightweight access points don't send control traffic.
Answer: C

NO.2 In the AP Layer 3 controller discovery process, after the LWAPP Discovery Request is broadcast on a
local subnet, what is the next step that the AP takes?
A. Determine whether the controller responses are the primary controller.
B. Send an LWAPP discovery request to controllers learned via OTAP if operational.
C. Send an LWAPP response to the master controller if known.
D. Wait 5 seconds and resend a Discovery Request to the local subnet.
Answer: B

NO.3 Up to how many Cisco WiSMs are supported in a single mobility group operating under v5.0 code?
A. 5
B. 12
C. 16
D. 24
E. 150
F. 300
Answer: B

NO.4 Which roaming situation using controllers in a Cisco Unified Wireless Network requires a client using
WPA2 with PKC to reauthenticate to the network?
A. A wireless client roams to another AP on a different controller in the same mobility domain.
B. A wireless client roams to another AP on the same controller.
C. A wireless client roams to another AP after being out of range of the network for 2 minutes.
D. A wireless client roams to another AP on a controller in a different mobility domain.
Answer: D

NO.5 When creating a wireless profile in the Cisco ADU and you have selected the WPA/WPA2/CCKM radio
button option, what other decision must you make and then configure on this same screen?
A. the address and the server secret of the authentication device you will authenticate with
B. the encryption type
C. the EAP type to be used for authentication
D. the length and value of the pre-shared key
E. the SSID of the wireless client
Answer: C

NO.6 What is the result when client exclusion is enabled with a timeout value of zero?
A. Clients are excluded indefinitely.
B. Clients are never excluded.
C. Client exclusion is disabled.
D. Clients must be explicitly included by specifying the MAC address.
E. Exclusion and inclusion is determined by access list.
Answer: A

NO.7 The central office is currently using a combination of 4400 and 2100 series WLAN controllers running
v4.2 and a variety of LWAPP-enabled access points servicing both 2.4 GHz and 5 GHz. The WLAN
deployment has been extended to each remote office by implementing a 526 WLAN controller running
v4.1 and several 521 access points. Wireless client deployment uses EAP-TLS authentication using a
centralized RADIUS server plus 802.11n for performance. After the first remote office deployment, remote
office users complain that they are not connecting via 802.11n.
What is the most likely cause of this problem?
A. The 526 WLAN controller does not support external authentication via RADIUS, prohibiting
authentication.
B. The 521 AP does not support 5 GHz, which prohibits 802.11n.
C. The 521 AP and 526 WLAN controllers do not support AES, which prohibits 802.11n.
D. The 526 WLAN controller does not support 802.11n with v4.1 and must be upgraded to v4.2.
E. The 526 WLAN controller does not support 802.11n with either v4.1 or v4.2.
Answer: E

NO.8 DRAG DROP
STUDY this as you will likely get this DRAG and DROP question! Exhibit:
Answer:

NO.9 Which three elements define the 802.11n implementation of MIMO? (Choose three.)
A. Channel Bonding
B. Dynamic Frequency Selection
C. Maximal Ratio Combining
D. Packet Aggregation
E. Spatial Multiplexing
F. Transmit Beam Forming
Answer: C,E,F

NO.10 Which CLI command shows the controller configuration in a way that is similar to the way that it is
displayed on Cisco IOS routers?
A. showconfig
B. show runconfig
C. show run-config
D. show runningconfig
E. show running-config
Answer: E

NO.11 A client is attached to the Cisco Unified Wireless network using controllers. When the client is using
WPA2 and EAP authentication, where are the wireless encryption keys located during the active user
session? (Choose two.)
A. on the access point
B. on the RADIUS server
C. on the Cisco WCS
D. on the client
E. on the Cisco WLC
Answer: A,D

NO.12 What is fading?
A. Another signal source is producing energy on the channel in which you are trying to operate.
B. The desired signal reaches the receiving antenna via multiple paths, each of which has a different
propagation delay and path loss.
C. A time-varying change in the path loss of a link with the time variance governed by the movement of
objects in the environment, including the transmitter and receiver themselves.
D. A function of the frequency and should be provided in the cable specification by the vendor.
E. The minimum signal level for the receiver to be able to acceptably decode the information.
F. The time delay from the reception of the first instance of the signal until the last instance.
Answer: C

NO.13 How do the features that are available on the Cisco WCS for Linux version differ from those of the Cisco
WCS for Windows version?
A. Assuming that there are no differences in hardware, a Cisco WCS for Linux can support up to 750
wireless LAN controllers. A Cisco WCS for Windows can support up to 250 wireless LAN controllers.
B. Cisco WCS for Windows includes support for Cisco Spectrum Expert clients. Cisco WCS for Linux
does not support Cisco Spectrum Expert clients.
C. Cisco WCS for Linux is required for deployments.
D. There are no differences in features between the Linux and Windows versions of Cisco WCS.
Answer: D

NO.14 Effective Isotropic Radiated Power is calculated by using which three values? (Choose three.)
A. antenna bandwidth
B. antenna gain
C. cable loss
D. receiver sensitivity
E. SSID
F. transmission power
Answer: B,C,F

NO.15 What three authentication methods are generally used in enterprise wireless networks? (Choose
three.)
A. AES
B. CCKM
C. EAP-FAST
D. EAP-TLS
E. PEAP
F. WEP
Answer: C,D,E

NO.16 Which two attacks does Management Frame Protection help to mitigate? (Choose two.)
A. Eavesdropping
B. Denial of Service
C. War Driving
D. Man-in-the-Middle
Answer: B,D

NO.17 Cisco Client Management Frame Protection is running on a mobility group with two controllers. Which
two MFP requirements protect the network? (Choose two.)
A. forces clients to authenticate, using a secure EAP method only
B. implements the validation of wireless management frames
C. requires CCXv5
D. requires the use of anonbroadcast SSID
E. requires CCXv4
Answer: B,C

NO.18 The existing Cisco Unified Wireless Controller is running v5.0 code for both the controllers and the
Cisco WCS. A controller has been configured with an appropriate rogue rule condition to report
discovered APs to the Cisco WCS. What default alarm level is used to display all rogue APs in the Alarm
Summary?
A. Critical
B. Flash
C. Major
D. Minor
E. Urgent
Answer: D

NO.19 Which limitation applies to the use of the Cisco WLAN Solution Management over Wireless feature.?
A. Controllers must be managed using only secure protocols (that is, SSH and HTTPS), notnonsecure
protocols (that is, HTTP and Telnet).
B. Read-write access is not available; only read-only access is supported.
C. Uploads and downloads from the controller are not allowed.
D. Wireless clients can manage other controllers however not the same controller and AP to which the
client is associated.
Answer: C

NO.20 Which four file formats are used when importing a single campus map into the Cisco WCS 5.0?
(Choose four.)
A.BMP
B.GIF
C.JPEG
D.JPG
E.PNG
F.VSD
G.MAP
H.XML
Answer: B,C,D,E