Pass4Test의 베터랑의 전문가들이 오랜 풍부한 경험과  IT지식으로 만들어낸 IT관련 인증시험 자격증자료들은 여러분이  Cisco 642-902 (Implementing cisco ip routing) 시험을 안전하게 패스하도록 도와드립니다. Pass4Test에서 제공하는  Cisco 642-902 (Implementing cisco ip routing) 덤프는 모두 100%통과 율을 보장하며 그리고 일년무료 업뎃서비스를 제공합니다.만약 아직도 Pass4Test의   Cisco 642-902 (Implementing cisco ip routing)  를 선택할지에 대하여 망설이고 있다면  우선 우리 사이트에서 Pass4Test가 제공하는 무료인 일부 문제와 답을 다운하여 체험해보시고 결정을 내리시길 바랍니다.그러면 우리의  Cisco 642-902 (Implementing cisco ip routing) 덤프에 믿음이 갈 것입니다.인재도 많고 경쟁도 많은 이 사회에, IT업계 인재들은 인기가 아주 많습니다.하지만 팽팽한 경쟁률도 무시할 수 없습니다.많은  IT인재들도 어려운 인증시험을 패스하여 자기만의 자리를 지켜야만 합니다.우리 Pass4Test에서는 마침 전문적으로 이러한 IT인사들에게 편리하게 시험을 패스할수 있도록 유용한 자료들을 제공하고 있습니다.  Cisco 642-902 (Implementing cisco ip routing) 인증은 아주 중요한 인증시험중의 하나입니다.

 

 

NO.1 Refer to the exhibit.
Which two statements are true about the partial configuration that is provided. (Choose two.)
A. All the configured neighbors are in autonomous system 100.
B. The peer group shortens the IBGP configuration.
C. The peer group shortens the EBGP configuration.
D. Only the outgoing filters are applied to BGP updates.
E. Three AS-path filters are applied to each BGP neighbor.
Answer: AB

NO.2 What are two rules for compacting IPv6 addresses? (Choose two.)
A. The maximum number of times a double colon can replace a 16-bit segment that consists of all zeroes
is two.
B. The leading zeroes in any 16-bit segment do not have to be written.
C. Every 16-bit segment that consists of all zeroes can be represented with a single colon.
D. The trailing zeroes in any 16-bit segment do not have to be written.
E. Any single, continuous string of one or more 16-bit segments that consists of all zeroes can be
represented with a double colon.
F. Two zeroes in the middle of any 16-bit segment do not have to be written.
Answer: BE

NO.3 During BGP configuration on a router that has peered with other BGP speakers, the BGP command
aggregate-address 172.32.0.0 255.255.252.0 is issued. However, the peers do not receive this aggregate
network in BGP advertisements. Also, the router does not have this aggregate network in its BGP table.
Which option indicates a possible reason this command did not cause the router to advertise the
aggregate network to its peers?
A. Interface NULL 0 is likely shutdown.
B. The BGP command no synchronization is missing.
C. The BGP command no auto-summary is missing.
D. Subnets of 172.32.0.0/22 do not exist in the BGP table.
E. The IGP running on this router does not have network 172.32.0.0/22 installed.
F. The next hop IP address must be a loopback address.
Answer: D

NO.4 Refer to the exhibit.
Router RTA is the hub router for routers RTB and RTC. The Frame Relay network is configured with
EIGRP, and the entire network is in autonomous system 1. However, router RTB and RTC are not
receiving each other's routes. What is the solution?
A. Configure the auto-summary command under router eigrp 1 on router RTA.
B. Issue the no ip split-horizon command on router RTA.
C. Configure subinterfaces on the spoke routers and assign different IP address subnets for each
subinterface.
D. Check and change the access lists on router RTA.
E. Issue the no ip split-horizon eigrp 1 command on router RTA.
F. Configure a distribute-list on router RTA that allows it to advertise all routes to the spoke routers.
Answer: E

NO.5 Refer to the exhibit. Router RT-1 chooses one path to network 198.133.219.0/24. Indicate the reason
Router RT-1 chooses this "best" path.
A. In making its decision about the best path, RT-1 gives precedence to the origin code.
B. In making its decision about the best path, RT-1 gives precedence to the BGP MED values.
C. IP address 128.107.2.2 is lower than 128.107.255.2.
D. In making its decision about the best path, RT-1 prefers the IGP metrics.
E. RT-1 prefers internal BGP routes.
F. IP address 128.107.254.2 is lower than 128.107.255.2.
Answer: A

NO.6 Into which two types of areas would an area border router (ABR) inject a default route.? (Choose two.)
A. the autonomous system of a different interior gateway protocol (IGP)
B. area 0
C. totally stubby
D. NSSA
E. stub
F. the autonomous system of an exterior gateway protocol (EGP)
Answer: CE

NO.7 A router has two paths to reach another network in a different autonomous system. Neither route was
generated by the local router and both routes have the same default weight and local preference values.
Which statement is true about how BGP would select the best path?
A. If the command bgp always-compare-med has been given, then the router will prefer the route with the
highest MED.
B. The router will prefer the route with the lower MED.
C. The router will prefer the shortest autonomous system path.
D. To influence one route to be preferred, its default local preference value will be changed via the use of
the command bgp default local-preference 50.
Answer: C

NO.8 Refer to the exhibit. Router RT-1 and router RT-2 both advertise network 131.25.0.0/16 to router RT-3
via internal BGP. What is the reason that router RT-3 chose router RT-1 as its best path to network
131.25.0.0/16.
A. It advertises the best AS-path.
B. It advertises the best origin code.
C. It advertises the best MED.
D. It advertises the best local preference.
E. It has a better router ID.
F. It advertises a lower autonomous system.
Answer: E

NO.9 How is authentication handled with OSPFv3?
A. OSPFv3 for IPv6 authentication is supported by SHA-1 authentication.
B. OSPFv3 for IPv6 authentication is supported by MD5 authentication.
C. OSPFv3 for IPv6 authentication is supported by IPv6 IPsec.
D. OSPFv3 for IPv6 authentication is supported by IPv4 IPsec.
Answer: C

NO.10 What two situations could require the use of multiple routing protocols? (Choose two)
A. when using UNIX host-based routers
B. when smaller broadcast domains are desired
C. because having multiple routing protocols confuses hackers
D. when migrating from an older Interior Gateway Protocol (IGP) to a new IGP
E. when all equipment is manufactured by Cisco
F. when there are multiple paths to destination networks
Answer: AD

NO.11 Refer to the output.
What IOS command produces this output? .
A. show ip ospf
B. show ip ospf interface
C. show ipv6 ospf interface
D. show ipv6 ospf
Answer: D

NO.12 What is the difference between the IPv6 addresses ::/0 and ::/128?
A. ::/0 is the unspecified address, and ::/128 is the multicast address.
B. ::/0 is the unicast address, and ::/128 is the anycast address.
C. ::/0 is the unicast address, and ::/128 is the multicast address.
D. ::/0 is the anycast address, and ::/128 is the multicast address.
E. ::/0 is the default route, and ::/128 is the unspecified address.
F. ::/0 is the anycast address, and ::/128 is the default address.
Answer: E

NO.13 Refer to the exhibit.
Which statement is true?
A. Router RAR1 will accept only route 10.10.0.0/19 from its BGP neighbor.
B. Router RAR1 will send only route 10.10.0.0/19 to its BGP neighbor.
C. Only traffic with a destination from 10.10.0.0/19 will be permitted.
D. Only traffic going to 10.10.0.0/19 will be permitted.
Answer: A

NO.14 Refer to the exhibit.
Which two statements are correct? (Choose two.)
A. All six routes will be installed in the routing table.
B. Two routes will be installed in the routing table.
C. Four routes will be installed in the routing table.
D. All the routes were redistributed into BGP from an IGP.
E. All the routes were originated by BGP with the network command.
Answer: CD

NO.15 Using the rules for IPv6 addressing, how can the address
2031:0000:240F:0000:0000:09C0:123A:121B be rewritten?
A. 2031:0:240F::09C0:123A:121B
B. 2031::240F::09C0:123A:121B
C. 2031::240F:9C0::123A:121B
D. 2031::240F:::09C0:123A:121B
Answer: A

NO.16 What are the two reasons for the appearance of 0.0.0.0 as the next hop for a network in the show ip bgp
command output? (Choose two.)
A. The network was originated via redistribution of an interior gateway protocol into BGP.
B. The network was defined by a static route.
C. The network was originated via a network or aggregate command.
D. The network was learned via EBGP.
E. The network was learned via IBGP.
Answer: AC

NO.17 Refer to the exhibit. On the basis of the information in the exhibit, which two statements are true?
(Choose two.)
A. The output was generated by entering the show ip bgp command on the ISP router.
B. The output was generated by entering the show ip bgp command on the SanJose1 router.
C. The serial 0/0/1 interface on the ISP router has been configured with the set metric 50 command.
D. The serial 0/0/1 interface on the ISP router has been configured with the set metric 75 command.
E. When traffic is sent from the ISP to autonomous system 64512, the traffic will be forwarded to
SanJose1 because of the lower MED value of SanJose1.
F. When traffic is sent from the ISP to autonomous system 64512, the traffic will be forwarded to
SanJose2 because of the higher MED value of SanJose2.
Answer: AE

NO.18 Refer to the partial configurations in the exhibit. What address is utilized for DR and BDR identification
on Router1?
A. the serial 1/1 address
B. the serial 2/0 address
C. a randomly generated internal address
D. the configured router-id address
Answer: D

NO.19 Which three restrictions apply to OSPF stub areas? (Choose three.)
A. No virtual links are allowed.
B. The area cannot be a backbone area.
C. Redistribution is not allowed unless the packet is changed to a type 7 packet.
D. The area has no more than 10 routers.
E. No autonomous system border routers are allowed.
F. Interarea routes are suppressed.
Answer: ABE

NO.20 Refer to the exhibit.
On the basis of the configuration that is provided, how would the BGP updates that come from router R1
be replicated inside autonomous system 65200?
A. All BGP updates that are received on router R2 will be sent to routers R3 and R4. Routers R3 and R4
will then forward those BGP updates to router R5.
B. All BGP updates that are received on router R2 will not be sent to routers R3 and R4.
C. All BGP updates that are received on router R2 will be sent directly to router R5.
D. None of the BGP updates that are received on router R2 will ever be received by router R5.
Answer: D