IT인증,IT자격증,IT자격증시험,IT인증시험

http://www.pass4test.net/

Cisco 400-101 (CCIE Routing and Switching Written Exam) 인증문제

꿈을 안고 사는 인생이 멋진 인생입니다. 고객님의 최근의 꿈은 승진이나 연봉인상이 아닐가 싶습니다. Cisco 400-101 (CCIE Routing and Switching Written Exam) 시험은 IT인증시험중 가장 인기있는 국제승인 자격증을 취득하는데서의 필수시험과목입니다.그만큼 시험문제가 어려워 시험도전할 용기가 없다구요? 이제 이런 걱정은 버리셔도 됩니다. Pass4Test의 Cisco 400-101 (CCIE Routing and Switching Written Exam) 덤프는 Cisco 400-101 (CCIE Routing and Switching Written Exam) 시험에 대비한 공부자료로서 시험적중율 100%입니다.

 

 

NO.1 Refer to the exhibit.

Which statement is true?

A. R1 routes this pseudowire over MPLS TE tunnel 1 with transport label 20.

B. The default route 0.0.0.0/0 is available in the IPv4 routing table.

C. R1 is using an MPLS TE tunnel for this pseudowire, because the IP path is not available .

D. R1 has preferred-path configured for the pseudowire.

Answer: D

 

NO.2 Which two statements about the function of the stub feature in EIGRP are true? (Choose two.)

A. It stops the stub router from sending queries to peers.

B. It stops the hub router from sending queries to the stub router.

C. It stops the stub router from propagating dynamically learned EIGRP prefixes to the hub routers.

D. It stops the hub router from propagating dynamically learned EIGRP prefixes to the stub routers.

Answer: B,C

 

NO.3 Which attribute is not part of the BGP extended community when a PE creates a VPN-IPv4

route while running OSPF between PE-CE?

A. OSPF domain identifier

B. OSPF route type

C. OSPF router ID

D. MED

E. OSPF network type

Answer: E

 

NO.4 Refer to the exhibit.

Which statement is true?

A. IS-IS has been enabled on R4 for IPv6, single-topology.

B. IS-IS has been enabled on R4 for IPv6, multitopology.

C. IS-IS has been enabled on R4 for IPv6, single-topology and multitopology.

D. R4 advertises IPv6 prefixes, but it does not forward IPv6 traffic, because the protocol has not been

enabled under router IS-IS.

Answer: A

 

NO.5 Which two tunneling techniques determine the IPv4 destination address on a per-packet basis?

(Choose two.)

A. 6to4 tunneling

B. ISATAP tunneling

C. manual tunneling

D. GRE tunneling

Answer: A,B

 

NO.6 Which statement describes the native VLAN concept in an ISL trunk?

A. It is the VLAN ID that is assigned to untagged packets.

B. It is the VLAN with highest priority.

C. It is the default VLAN for a trunk.

D. There is no native VLAN concept in an ISL trunk.

Answer: D

 

NO.7 Refer to the exhibit.

The interface FastEthernet0/1 of both routers R4 and R5 is connected to the same Ethernet segment

with a multicast receiver. Which two statements are true? (Choose two)

A. Multicast traffic that is destined to a receiver with IP address 192.168.2.6 will flow through router

R4.

B. Both routers R4 and R5 will send PIM join messages to the RP.

C. Only router R5 will send a multicast join message to the RP.

D. Multicast traffic that is destined to a receiver with IP address 192.168.2.6 will flow through router

R5.

Answer: C,D

 

NO.8 Which statement is true regarding UDLD and STP timers?

A. The UDLD message timer should be two times the STP forward delay to prevent loops.

B. UDLD and STP are unrelated features, and there is no relation between the timers.

C. The timers need to be synced by using the spanning-tree udld-sync command.

D. The timers should be set in such a way that UDLD is detected before the STP forward delay

expires.

Answer: D

 

Posted 2014/10/30 10:24:37  |  Category: cisco  |  Tag: 400-101인증문제