만약Cisco인증200-125시험문제을 통과하고 싶다면, Pass4Tes의 선택을 추천합니다. Pass4Tes선택은 가장 적은 투자로 많은 이익을 가져올 수 있죠, Pass4Tes에서 제공하는Cisco인증200-125시험문제로 시험패스는 문제없스니다. Pass4Test는 전문적으로 it인증시험관련문제와 답을 만들어내는 제작팀이 있으며, Pass4Tes 이미지 또한 업계에서도 이름이 있답니다
시험 번호/코드: 200-125시험 이름: CCNA Cisco Certified Network Associate CCNA (v3.0)
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 200-125시험문제
PDF 및 소프트웨어, 연구와 실천
시험 번호/코드: 200-105시험 이름: Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0)
당신이 구입하기 전에 시도, 100% 합격율 보장
100% 환불보장약속 200-105인증
PDF 및 소프트웨어, 연구와 실천
IT업계에 계속 종사할 의향이 있는 분들께 있어서 국제공인 자격증 몇개를 취득하는건 반드시 해야하는 선택이 아닌가 싶습니다. Cisco 200-105인증 시험은 국제공인 자격증시험의 인기과목으로서 많은 분들이 저희Cisco 200-105인증를 구매하여 시험을 패스하여 자격증 취득에 성공하셨습니다. Cisco 200-105인증 시험의 모든 문제를 커버하고 있는 고품질Cisco 200-105인증를 믿고 자격증 취득에 고고싱~!
Pass4Test의 덤프선택으로Cisco 200-105인증에 응시한다는 것 즉 성공과 멀지 않았습니다. 여러분의 성공을 빕니다.
200-105 덤프무료샘플다운로드하기: http://www.pass4test.net/200-105.html
NO.1 What is the result of issuing the frame-relay map ip 192.168.1.2 202
broadcast command?
A. defines the DLCI that is used for all packets that are
sent to the 192.168.1.2 IP address
B. defines the source IP address that is
used in all broadcast packets on DCLI 202
C. defines the destination IP
address that is used in all broadcast packets on DCLI 202
D. defines the DLCI
on which packets from the 192.168.1.2 IP address are received
Answer:
A
200-105자격증덤프
Explanation:
Frame-relay
map ip 192.168.1.2 202 command statically defines a mapping between a network
layer
address and a DLCI. The broadcast option allows multicast and broadcast
packets to flow across the
link. The command frame-relay map ip 192.168.1.2
202 broadcast means to mapping the distal IP
192.168.1.2 202 to the local
DLCI . When the "broadcast" keyword is included, it turns Frame Relay
network
as a broadcast network, which can forward
broadcasts.
http://www.cisco.com/en/US/docs/ios/wan/command/reference/wan_f2.html#wp1012264
NO.2
Refer to the exhibit.
Why has this switch not been elected the root bridge
for VLAN1?
A. It is running RSTP while the elected root bridge is running
802.1d spanning tree.
B. It has a higher bridge ID than the elected root
bridge.
C. It has more than one interface that is connected to the root
network segment.
D. It has a higher MAC address than the elected root
bridge.
Answer: B
200-105
PDF
Explanation:
http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a008009482f.s
html
When a switch receives a BPDU, it first compares priority, the lower
number wins. If a tie, compare
MAC, the smaller one wins. Here Switch has
32769 priority which is greater than 20481 so switch will
not elect for root
bridge. It says the bridge priority for Switch is 32769, and the root priority
is 20481.
Which means that some other switch has the lower priority and won
the election for VLAN 1.
NO.3 What occurs on a Frame Relay network when
the CIR is exceeded?
A. All UDP traffic is marked discard eligible and a BECN
is sent.
B. All traffic exceeding the CIR is marked discard eligible.
C.
All TCP traffic is marked discard eligible and a BECN is sent.
D. All TCP
traffic is marked discard eligible.
Answer: B
200-105자격시험 200-105교육
Explanation:
Committed
information rate (CIR): The minimum guaranteed data transfer rate agreed to by
the
Frame Relay switch. Frames that are sent in excess of the CIR are marked
as discard eligible (DE)
which means they can be dropped if the congestion
occurs within the Frame Relay network. Note: In
the Frame Relay frame format,
there is a bit called Discard eligible (DE) bit that is used to
identify
frames that are first to be dropped when the CIR is
exceeded.
NO.4 Which term describes a spanning-tree network that has all
switch ports in either the blocking or
fowarding state?
A. spanned
B.
provisioned
C. converged
D. redundant
Answer:
C
Explanation:
Spanning Tree Protocol convergence (Layer 2 convergence)
happens when bridges and switches have
transitioned to either the forwarding
or blocking state. When layer 2 is converged, root bridge is
elected and all
port roles (Root, Designated and Non-Designated) in all switches are
selected.