Pass4Test의 Cisco 648-247 (Implementing Cisco Connected Physical Security 2 Exam)  덤프는 고객님의 IT인증자격증을 취득하는 소원을들어줍니다. IT업계에 금방 종사한 분은 자격증을 많이 취득하여 자신만의 가치를 업그레이드할수 있습니다. Pass4Test의  Cisco 648-247 (Implementing Cisco Connected Physical Security 2 Exam) 덤프는 실제 시험문제에 대비하여 연구제작된 퍼펙트한 시험전 공부자료로서 시험이 더는 어렵지 않게 느끼도록 편하게 도와드립니다.

 

 

NO.1 When a 24 VDC fail safe lock is being used to secure a door, how should power be supplied to the lock
from the control source?
A. connected +24 VDC directly to the lock
B. connected +24 VDC through common and normally close
C. connected +24 VDC through common and normally open
D. connected +5 VDC binary control signaling
Answer: B

NO.2 What are the three common methods that are used for authentication with an access control system.?
A. badge card, key fob, and keypad PIN
B. badge card, keypad PIN, and password
C. something you know, something you have, and something you are
D. something you know, something you have, and something you did
Answer: C

NO.3 What are the four main components of a typical logical door?
A. door, door knob, door jam, and hinges
B. lock, reader, tailgate sensor, and motion detector
C. lock, request to exit, door position switch, and swing arm
D. lock, reader, request to exit, and door position switch
Answer: D

NO.4 Refer to the exhibit.
One or more expansion modules is connected to the Cisco Access Gateway via a CAN bus. How should
the CAN bus wires be connected after the last module in the chain?
A. The CAN bus wires should be looped back to the Cisco Access Gateway.
B. The CAN bus wires should be twisted together and tucked away.
C. The CAN bus wires should be plugged into a Layer 2 Ethernet switch.
D. The CAN bus wires should be terminated with a high-impedance resistor.
Answer: D

NO.5 Cisco Physical Access Manager (Cisco PAM) is an appliance-based solution. The Cisco PAM 1.3.2
appliance is available on which of the following server platforms?
A. CIVS-MSP-1RU-K9
B. CPS-MSP-1RU-K9
C. CPS-MSP-2RU-K9
D. CIAC-PAME-1125-K9
Answer: B